Evaluate how much work does the force do on the block

Assignment Help Physics
Reference no: EM13563715

A floating ice block is pushed through a displacement vector d= (15 m)i - (12 m)j along a straight embankment by rushing water,which exerts a force vector F = (210 N)i - (150 N)j on the block. How much work does the force do on the block during the displacement?

Reference no: EM13563715

Questions Cloud

What is the maximum so2 discharge rate : An electric utility wants to build a new coal fired power plant in an urban setting. The regulatory agency has determined that in order for the plant to be permitted it must limit its emissions to prevent the ground level SO2 concentration from excee..
What is the maximum height of the balloon : A 1.50 kg water balloon is shot straight up with an initialspeed of 5.00 m/s. What is the maximum height of the balloon
How would you structure a portion of an aviation safety : Find the limiting length of an offset so that the displacement of a point on paper is may not exceed 0.025 centimetres.The offset was laid 3 degree out from it's true direction and the scale was 10m to 1cm.
Evaluate how much work did her force do on the car : In1960 a Tampa, Florida, mother reportedly raised one end of a carthat had fallen onto her son when jack failed. how much work did her force do on the car
Evaluate how much work does the force do on the block : A floating ice block is pushed through a displacement vector d= (15 m)i - (12 m)j along a straight embankment by rushing water, How much work does the force do on the block during the displacement
What is the work done on the man by the gravitational force : A 87.0-kg man is riding an escalator in a shopping mall. What is the work done on the man by the gravitational force
How long did it take for the rocket to reach that maximum : A single stage rocket is fired from a launch pad just in front of the Library. The rocket engines impart a constant acceleration of 20 m/sec/sec for a total time of 40 sec. At that time, there is no more fuel in the rocket engine and the rocket conti..
Check the adequacy of the beam with respect to the moment : A reinforced concrete beam having the cross section shown is on a simple span of 28ft. It carries uniform service loads of 3.60 kips/ft live load and 2.20 kips/ft dead load. Check the adequacy of the beam with respect to the moment. Use f1c= 3000 psi..
What will the volume of the sample be when the water content : A saturated 100 cm^3 clay sample has a natural water content of 30 percent. it is found that the shrinkage limit occurs when the water content is 19 percent. if the specific gravity of soil solids is 2.70 what will the volume of the sample be when th..

Reviews

Write a Review

Physics Questions & Answers

  What is the direction of motion of the second car

On an icy (nearly frictionless) street a 600 kg car traveling straight east at 5 m/s collides with a 1000 kg car traveling straight north at 3 m/s. what is the direction of motion of the second car

  What is the net charge on the ball

A small, 2.10 g plastic ball is suspended by a 20.0 cm long string in a uniform electric field E = 5.60×103 i N/C, If the ball is in equilibrium when the string makes a 15.0o angle with the vertical

  What is the electric flux through the rectangle

A 5.70 cm x 3.10 cm rectangle lies in the xy-plane, What is the electric flux through the rectangle if E = (50.0 i-hat + 60.0 k-hat) N/C

  Calculate how high will the other ball go after collision

A 4.60-kg ball is dropped from a height of 10.0m above one end of a uniform bar that pivots at its center. How high will the other ball go after the collision

  Find how many time constants must elapse

How many time constants (a decimal number) must elapse before a capacitor in a series RC circuit is charged to 75.0% of its equilibrium charge

  Find the resistance of the rod

here is a potential difference of 5.0 V between the ends of a 60 cm long graphite rod that has a cross-sectional area of 1.0 mm2. Find the resistance of the rod

  Find the direction of the magnetic force on the rod

Parallel conducting tracks, separated by 2.79 cm, run north and south. There is a uniform magnetic field of 1.27 T pointing upward (out of the page). What is the direction of the magnetic force on the rod

  Find the rate of heat conduction along the rod

One end of a 30 cm long aluminum rod with diameter 2 cm is kept at 460*C while the other end is held in water at 25*C

  Calculate what is its speed as it leaves the faucet

Water is flowing through a pipe (area 3.7 cm2) that connects to a faucet adjusted to have an opening of 0.45 cm2. what is its speed as it leaves the faucet

  What is the change in entropy of the water

A sophomore with nothing better to do adds heat to 0.350 kg of ice at 0.00°C until it is all melted. What is the change in entropy of the water

  Estimate how much of the height of the cylinder is in oil

A solid cylinder ABCD (radius: 0.150 m, height: 0.120 m) has the mass of 7.00 kg. How much of the height of the cylinder is in the oil

  What is the highest order diffraction minimum produced

Monochromatic light at 441 nm is normally incident on an opaque film having a single slit of width 0.02 mm. What is the highest order diffraction minimum produced

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd