Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A rectangular forced air heating duct is suspended from the ceiling of a basement whose air and walls are at a temperature of T00 = Tsur = 5°C. The duct is 15 m long, and its cross section is 350 mm X 200 mm.
(a) For an uninsulated duct whose average surface tem- perature is 50°C, estimate the rate of heat loss from the duct. The surface emissivity and convection coefficient are approximately 0.5 and 4 W/m2 · K, respectively.
(b) If heated air enters the duct at 58°C and a velocity of 4 m /s and the heat loss corresponds to the result of part (a), what is the outlet temperature? The density and specific heat of the air may be assumed to be p= 1.10 kg/m3 and cp = 1008 J/kg · K, respectively.
A cylinder with a piston restrained by a linear spring contains 2kg of carbon dioxide at 500 kPa, 400 C the system is now cooled to 40C, at which point the pressure is 300 kPa. You may assume ideal gas behavior with constant specific heat value Cv=0...
a gallon of liquid gasoline contains about 131 mj 124340 btu of energy. this fuel is atomized and burned with the
three kilograms of air is in a pistoncylinder keeping constant pressure at 27 celsius 300 kpa. it is not heated to
wetting of some metallic surfaces can be inhibited by means of ion implantation of the surface prior to its use thereby
In order to increase production rate, a reactor setpoint was increased from 160 psig to 190 psig. The reactor pressure transmitter was recalibrated from 0- 200 psig to 0- 300 psig. What is the percent span for the old and new setpoints?
A polymer is subjected to a cyclic stress of 5 MPa at a frequency of 1 Hz for 1 min. The phase angle is 0.05?. Calculate the temperature rise assuming no loss to the surroundings. E = 2GPa, C = 1.0 J/kg · K, and ρ = 1.0 Mg/m3.
A pressure cooker has a volume of 5 L and an operating temperature of 120 C. Initially, 99% of the mass is filled with liquid water and the rest with vapor. Heat is supplied at a rate of 1.5 kW.
The rack structure will be built 2 ft above floor level, and the clearance between the rack structure and the ceiling of the building must be at least 18 in. Determine the dimensions (height, length, and width) of the rack structure.
water behind a dam enters an intake pipe at a pressure of 1.05 bar and velocity of 1 ms flow through a hydraulic
a rectangular channel 3-m-wide carries 10 m3s at a depth of 2m. is the flow subcritical or supercritical? for the same
an insulation system is to be selected for a furnace wall at l000degc using first a layer of mineral wool blocks
a double acting cylinder with a single rod must produce a thrust of 80kn and move out with a velocity of 3mms on the
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd