Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A combination of silver/silver chloride and cadmium electrodes are used for biomedical application.
a.) Estimate the half-cell potentials of each of the electrodes assuming the potentials don't change between 25deg and body temp.
b.)What would the reading be on a volt meter connected between the two electrodes? (silver/silver chloride annode, cadmium cathode)
c.) Can these two dissimilar electrodes on the body or perhaps a whole bunch of these pairs on the body in series be used as a battery to power electronic devices? Why/Why not?
The system contains a door sensor, a window sensor, and a key activation switch. If the switch is on, opening the window will set off the alarm immediately. Opening the door will start a 30 second timer.
Describe whether Google is exploitive, impoverished, supportive, or enlightened. Describe the features google that indicate which kind of organization it is. Describe five steps google could take to become better and move up in the scale.
V1(18V) R1(1k) R2 (1.5k) R3 (2k)How does the ratio V2 V1 compare to the raioR2 R1?How does the ratio V3 V1 compare to the raioR3 R1 Add the measured voltage V1 V2 and V3 How does this value compare to the value Vt
A double-A (AA) rechargeable battery is rated at 1.2V, 2100mAh (mili-amp hours) 1- how many coulombs of charge can this battery hold 2- how many joules of energy are stored in the battery
Using eye diagram drawings of PAM NRZ waveforms used to transmit bits in the baseband show and explain how awgn can effect bit error rates and how timing jitter can effect bit error rates.
A 10 kW, 220 V, dc shunt motor has field and armature reistance of 110 ohms and .20 ohms, respectively. At no-load the motor runs at 1200 rpm and has an armature current of 5 A.
Restricting yourself to nondegenerate dopings and also requiring the resistance to be readily measured with a hand-held multimeter (say 1 R 1000), what is the range of doping Pick a doping concentration in the mid range.
A measurement signal has a frequency less than 1 kHz, but there is unwanted noise at about 1 MHz. Design a low-pass filter that attenuates the noise to 1%. What is the effect on the measurement signal at its maximum of 1 kHz
Design low pass active filter with a cutoff frequency t at 10kHz or more by 30db and have the pass band gain positive that does not deviate from 20db by more than 3db. The pass band frequency needed is 800Hz and below Derive transfer function
A Si (ni = 1 e+10 cm^-3, eps = 11.7) p-n junction is doped with NA = 5.2 e+18 cm^-3 and ND = 8.4 e+14 cm^-3. What reverse bias (the absolute value) should be applied to the junction, in order to achieve the maximum electric field of 3.89E+4 V/cm
A Na+ ion moves from inside a cell, where the electric potential is -70 mV , to outside the cell, where the potential is 0 V. What is the change in the ion's electric potential energy as it moves from inside to outside the cell
The base class must also have a virtual print() function that displays the class name. Randomly assign print functions in three other classes that display the class name. Create 7 pointers of the base class and have them point to all the classes.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd