Estimate the force on the chimney and the bending moment at

Assignment Help Mechanical Engineering
Reference no: EM13635441

A 10m height chimney has a 2.0m x 2.0m square cross section. The wind blows horizontally in a direction which is parallel to one of the diagonals of the cross section.

Careful measurement shows that, at height y from the ground, the magnitude of the wind velocity is given by:

u = 1.16 * Unom* log(750*y) for y > 1m

where Unom = 5m/s.

The density and viscosity of air are 1.2 kg/m3 and 2.0x10-5 m2/s respectively.

a) Estimate the force on the chimney and the bending moment at the bottom of the chimney. You may assume that the effect of the wind on the first 1 m height of the chimney has a negligible effect on the force and the moment.

b) How would you improve the accuracy of your estimation?

Reference no: EM13635441

Questions Cloud

Write a structural formula for a molecule containing three : write a structural formula for a molecule containing three carbonatoms that represent ans alcohol an organic acid and
A hydraulic jump forms in a horizontal trapezoidal channel : a hydraulic jump forms in a horizontal trapezoidal channel. the base width is 4m and the side slopes are 45 degrees.
Assume that adults have iq scores that are normally : assume that adults have iq scores that are normally distributed with a mean of u 100 and a standard deviation 20. find
This solution has an osmotic pressure of 250 atm at 25 : a 0.500-g sample of a compound is dissolved in enough water to form 100.00 ml of solution. this solution has an osmotic
Estimate the force on the chimney and the bending moment at : a 10m height chimney has a 2.0m x 2.0m square cross section. the wind blows horizontally in a direction which is
An axon is the relatively long tail-like part of a neuron : an axon is the relatively long tail-like part of a neuron or nerve cell. the outer surface of the axon membrane
The nutritional calorie calorie is equivalent to 1 kcal : the nutritional calorie calorie is equivalent to 1 kcal. onepound of body fat is equivalent to about 4.1 multiplied by
Set up the hypotheses for the test to determine if there : suppose that as a quality control consultant you know the population of machine operators for a corporation has a
Two 5 gram spheres are each suspended from a pin by a 40 cm : two 5 gram spheres are each suspended from a pin by a 40 cm long non-conducting thread. if the spheres are separated

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The uniform slender has a mass of 15 kg determine the

the uniform slender has a mass of 15 kg. determine the horizontal and vertical components of reaction on pin o and the

  A company crates its products for shipping as shown base

a company crates its products for shipping as shown base plate with two springs holding a crate- mass suspended in

  As the argon passes through the pipe it is heated in a

argon at 20 degrees c and 100kpa has a velocity of 27 ms and enters a constant diameter pipe of 18mm. as the argon

  Design a process for the manufacture of 106 kg per year of

design a process for the manufacture of 106 kg per year of mayonnaise. the shelf life of the product is expected to be

  Increasing the boiler pressure to 600psia while maintaining

a steam power plant is proposed to operate between the pressures of 8psia and 450psia with a max temperature of

  A single-stage passive low-pass rc filter is designed to

a single-stage passive low-pass rc filter is designed to have acut-off frequenccy fc of 100 hz. its resistance equals

  Hi i need your help hi i study in university in greecei

hi i study in university in greece...i need your help until tomorrow for a mechanical draw.. ltbrgti must draw the

  Automatic control

DOF system and Find the differential equation describing the system

  Assume that a jet touches down 170 mph and its speed is

assume that a jet touches down 170 mph and its speed is reduced to zero in 240 ft. assuming a constant deceleration

  Calculate the friction factor and the heat transfer

air at atmospheric pressure and with a mean velocity of 0.5 ms flows inside a thin walled square cross-section duct of

  Determine the time taken for the product to freeze if it is

a fruit juice containing 30 solids of molecular weight 100 g was placed in a tray length 100 cm height 90 cm width 8

  The saturation pressure corresponding to this temperature

a rankine cycle with regeneration has steam enter a turbine at 30 bars and 500 degrees c. the condenser pressure is 0.1

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd