Estimate the average temperature of the earth

Assignment Help Mechanical Engineering
Reference no: EM131347871

Radiation from the sun

1. The sun's radiation can be approximated by a black body. The surface temperature of the sun is about 5800 K and its radius is 0.7 × 109 m. The distance from the earth to the sun is 1.5 × 1011 m. The radius of the earth is 6.4 × 106 m. Estimate the average temperature of the earth from this information. Be careful to state your assumptions and approximations explicitly.

2. From the nature of your assumptions in the previous question (rather than your knowledge of the actual temperature), would you expect a more accurate calculation with this data to give a higher or lower answer? Explain your reasons clearly to obtain one bonus point per reason.

Reference no: EM131347871

Questions Cloud

Determine the actual molar and mass air fuel ratios : Determine the actual molar and mass air/fuel ratios.- The percent of theoretical air used.- The molar percentage of water vapor in the exhaust gas before it was dried for this analysis.
Companies embark on cross-border strategic alliances : 1. Discuss the reasons that companies embark on cross-border strategic alliances. What other motivations may prompt such alliances?What are the driving forces for firms in emerging economies to embark on strategic alliances? How can SMEs expand ab..
Determine volumetric percentage of water vapor : Determine the actual molar and mass air/fuel ratios.- The percent deficit air used.- The volumetric percentage of water vapor in the exhaust gas before it was dried for this analysis.
Explain company that demonstrate successful winning strategy : Identify a company that demonstrated a successful winning strategy or experienced a strategy failure and briefly describe the circumstances in enough detail to communicate what happened.
Estimate the average temperature of the earth : Estimate the average temperature of the earth from this information. Be careful to state your assumptions and approximations explicitly.
What is potential concern regarding the royalty income : What is a potential concern regarding the royalty income from a retiring musician that may need to be addressed? What investment class (equity, fixed income, real estate etc.) do the royalty payments mimic? Why? Mr. W informs you that at retirement h..
Determine the composition of the fuel on a mass basis : Determine the fuel model (CnHm).- The composition of the fuel on a mass basis.-  The percent theoretical air used.
Create a memo proposal using the aida model : Create a memo proposal using the AIDA model in a Microsoft® Word in a minimum of 1,400 words.
Review the media piece capstone strategy playbook : Review the media piece Capstone Strategy Playbook for Exceptional Results: Description of the Playbook. This media piece provides a description of the contents of the Strategy Playbook.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Effect of the cooling water flow rate

Consider the counterflow, concentric tube heat exchanger of Example 11.1. The designer wishes to consider the effect of the cooling water flow rate on the tube length. All other conditions, including the outlet oil temperature of 60°C, remain the ..

  Determine the maximum allowable distance y

For the siphon in Fig. 6.26, assume that the volume flow rate is 5.6 X 10-3m3 /s. Determine the maximum allowable distance Y if the minimum allowable pressure in the system is -18 kPa (gage).

  Consider a gas turbine cycle with two stages of compression

consider a gas turbine cycle with two stages of compression and two stages of expansion. the pressure ratio across each

  The uniform disk of mass pivots freely on the cart of mass

the uniform disk of mass pivots freely on the cart of mass. determine the acceleration of the assembly and the angular

  A thin walled cylindrical pressure vessel has an outer

a thin walled cylindrical pressure vessel has an outer diameter of 7.50 in and wall thickness of 0.250 in with an

  Power rating of electric heating element immersed in water

Water is boiled at sea level in a coffee maker equipped with an immersion-type electric heating element. The coffee maker contains 1 L of water when full. Once boiling starts, it is observed that half of the water in the coffee maker evaporates in 25..

  B determine the maximum velocity attained by the collar a

the system is released from rest in the position shown. the masses of the collar a and the box b are ma 90 kg and mb

  Perpendicular to the centroidal axis of the column

Assume E=31 ,000 MPa and ν=0.2 εa=-222x10-6 , εb=-213x10-6 , εc=45x10-6 Where gauges a, b and c are in line with, at 450 to and perpendicular to the centroidal axis of the column, respectively.

  The exit temperature, in °r

The exit temperature, in °R

  The electronic components of a computer consume

The electronic components of a computer consume 0.1 kW of electrical power. To prevent overheating, cooling air is supplied by a 20-W fan mounted at the inlet of the electronics enclosure. At steady state, air enters the fan at20 °C, 1 bar and exits ..

  Find the speed of the center-of-mass

A uniform circular disk of mass m = 1 kg and radius R = 0:4m rolls down an incline. Suppose the disk starts rolling from rest. Find the speed of the center-of-mass when the disk is 2m down the inclined plane.

  Compute the electrical conductivity

Compute  the  electrical  conductivity of a 7.0-mm (0.28-in.) diameter cylindrical sil- icon specimen 57 mm (2.25 in.) long in which a current of 0.25 A passes in an axial direction. A voltage of 24 V is measured across  two  probes  that   are   ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd