Electronic components of computer are cooled by air flowing

Assignment Help Mechanical Engineering

Reference no: EM13708229

The electronic components of a computer are cooled by air flowing through a fan mounted at the inlet of the electronic enclosure. At steady state, air enters at 18oC, 1 atm. For noise control, the velocity of the entering air cannot exceed 0.9 m/s. For temperature control, the temperature of the air at the exit cannot exceed 34oC. The electronic components and fan receive, respectively, 68 W and 12 W of electric power. Determine the smallest fan area, in cm2, for which the limits on the entering air velocity and exit air temperature are met.

Reference no: EM13708229

Questions Cloud

Develop a preliminary design : Develop a preliminary design, including flow rates, pipe sizes, and pipe slopes for a trunk sewer to be laid in the development shown in the accompanying figure from 6th to 1st Streets along Peavy Avenue

Calculate the pressure at the nozzle exit : Moist air at 35 degree C, 3 bar, and relative humidity 30% (State 1) enters a nozzle with a velocity of 50 m/s and expands in a reversible and adiabatic process such that the moist air leaving the nozzle is about to condense (State 2). Calculate the ..

Calculate the mass flow rate of moist air : A non-reacting gaseous mixture with molar analysis of 74.3% N2, 4.3% O2, 7.1% CO2, and 14.3% H2O(g) enters a counter-flow heat exchanger at 800?F and 1 atm with a volumetric flow rate of 5 ft3/s (State 1) and exits at 200?F (State 2). Calculate the m..

How long will it take for half of the water to drain out : An open cylindrical tank that is 2 ft in diameter and 4 ft high is full of water. If the tank has a 2 in diameter hole in the bottom, how long will it take for half of the water to drain out, if friction is neglected?

Electronic components of computer are cooled by air flowing : The electronic components of a computer are cooled by air flowing through a fan mounted at the inlet of the electronic enclosure. At steady state, air enters at 18oC, 1 atm. For noise control, the velocity of the entering air cannot exceed 0.9 m/s. F..

Determine the velocity of the water at the inlet and exit : A pump is employed to deliver liquid water from a pond to a higher elevation. The pump steadily draws water from the pond at a volumetric flow rate of 192 gal/min through a pipe having a 7 in diameter inlet. The exit diameter of the pipe is 2 in. and..

Show the specs of bearers and joists : You need to park a car under it so there can be no supports in the middle. Attached to the wall on one side and steel post on the other.

Determine the volumetric flow rates at the inlet : Refrigerant 22 enters an insulated compressor operating at steady state as saturated vapor at -16oC with a mass flow rate of 1.5 kg/s. Refrigerant exits at 7 bar, 70oC. Changes in KE and PE from inlet to exit can be ignored.

Reduces volumetric efficiency at high engine speeds : A four-stroke engine has a total displacement volume of 10L, 125mm bore and 16.3:1 compression ratio. The engine produces a maximum of 210 kW at 2100 RPM. The intake air is at 45 degrees C and 22.5 g/s of air flow into each cylinder. Calculate the vo..

User Account

All Pages