Dtermine the following i the pump work kjkg assuming an

Assignment Help Mechanical Engineering
Reference no: EM13618145

A steam power plant operates on a Rankine cycle between pressure limits of 0.08 bar and 80 bar. The heat added by combustion in the boiler is 3166 kJ/kg. Steam enters the condenser with a quality of 90% and exits as a saturated liquid. Determine the following: I) the pump work (kJ/kg), assuming an isentropic process II) the turbine work (kJ/kg) III) the isentropic turbine efficiency IV) the cycle thermal efficiency.

Reference no: EM13618145

Questions Cloud

For the compressor the isentropic efficiency is 89 and for : air enters the compressor of an air-standard brayton cycle with a volumetric flow rate of 60 m3s at 0.8 bar 280 k. the
The steam expands through the first turbine stage to 07 : consider an ideal rankine cyle steam power plant with reheat. superheated vapor enters the first turbine stage at 10
If a force f 200 n is applied perpendicular to the bar at : a uniform bar ab of mass m 1.00 kg and length l 30.0 cm lies a horizontal plane. an additional mass m 1.00 kg is
Calculate the rate of water removal from the condenser the : an air conditioner is used to cool and dehumidify air. we will ignore the temperature aspect and model the air
Dtermine the following i the pump work kjkg assuming an : a steam power plant operates on a rankine cycle between pressure limits of 0.08 bar and 80 bar. the heat added by
A pitot-static tube is used to measure the velocity of 20 : a pitot-static tube is used to measure the velocity of 20 degrees c 68f water flowing in an open channel. if a
Determine the standard error of estimate determine the : the city council of pine bluffs is considering increasing the number of police in an effort to reduce crime. before
What pressure differential in inches of hg should exist : an 8 in. id pipe is connected by means of a reducer to a 6 in. id pipe. kerosene flows through the system at 2000
Show the process on a pressure volume diagram locate the : a frictionless piston cylinder device contains 10kg of nitrogen initially at 200kpa and 27c. the nitrogen is now heated

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Determine the pressure in the gas main if the pressure in

natural gas methane flows from a 33-in diameter gas main through a 1-in-diameter pipe and into the burner of a furnace

  What is the elastic modulus of the material

A beam of span 600mm has a load of 1 kg and deflects by 0.55mm its width is 25.4mm and depth is 6.7mm what is the elastic modulus of the material?

  Determine the work kj performed by the air in the cylinder

initially 0.05 kg of air is contained in a piston-cylinder device at 200 degc and 1.6 mpa. the air then expands at

  Compare calculated tensile stress with allowable tensile

a 120-in long annealed rod with a cross-section area of 0.86 in2 extruded from 5083 aluminum alloy has been axially

  Two blocks a and b are arranged with pulleys as shown block

two blocks a and b are arranged with pulleys as shown. block a has an initial velocity t 0s to the left of va1.2 ms.

  Such a cylinder with a 3in diameter piston and 2in

a double-rod cylinder is one in which the rod extends out of the cylinder at both ends. such a cylinder with a 3in

  A satellite is in earth with an altitude at perigee of 550

a satellite is in earth with an altitude at perigee of 550 km and an altitude at apogee of 5000 kma what is the

  Determine the tensions developed in wires

Determine the tensions developed in wires , and and the angle required for equilibrium of the 30-lb cylinder E and the 60-lb cylinder F.

  Hazen-williams formula -find the diameter of a pipe

Hazen-Williams Formula- Find the Diameter of a Pipe, The length of cast-iron pipe is to be 4200 ft., and the head causing flow is to be 12.6ft. After the pipe has been in service 5 years, it is expected to discharge water at a rate equal to 3.2 cf..

  Saturated liquid leaves the condenser at 006 bar the

superheated steam at 120 bar and 520c leaves the steam generator of a vapor power plant and enters a turbine with an

  Find the natural frequency

Three springs anda mass are attached to a rigid, weightless bar PQ hinged at one end. How do I find the natural frequency?

  An electric motor of total weight 3330 pounds is mounted on

an electric motor of total weight 3330 pounds is mounted on a simply supported beam with an overhang as shown

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd