Drum pressure and drum temperature

Assignment Help Mechanical Engineering

Reference no: EM13720681

A feed that is 50 mol% methane, 10 mol% n-butane, 15 mol% n-pentane, and 25 mol% n-hexane is flash distilled. F=150 kmol/h. Drum pressure =250 kPa, drum temperature =10 degrees celcius. use the depriester charts. find V/F, xi, yi, V, L.

Reference no: EM13720681

Questions Cloud

What will be the velocity and flow rate for the model : A dam spillway is tested with a 1/30th scale model, matching the Froude number. The flow over the dam has an average velocity of 0.6 m/s and a volume flow rate of 0.08 m^3/s.

What pressure should the air in the wind tunnel : A model of an airplane is to be tested at 20°C in a wind tunnel. The model is built to 1/12th scale. In order to match both the Mach number and the Reynolds number of the plane, the wind tunnel is pressurized. To what pressure (in atm) should the air..

Determine the overall heat transfer coefficient U : A deep freezer for hazardous chemicals is to be maintained at -20oF to insure a safe environment for the chemicals. The freezer is in a room that is kept at 60oF, and the inner and outer walls of the freezer are made of 26-gauge (0.0184-in) steel.

Determine the K-values from a DePriester chart : A stream containing 57 mol % n-Octane and the remainder Ethylene is to be separated by flash distillation. The molar flow rate of the stream is 823 mol/hr. The temperature and pressure of the stream entering the flash drum are 105°C and 325 kPa. De..

Drum pressure and drum temperature : A feed that is 50 mol% methane, 10 mol% n-butane, 15 mol% n-pentane, and 25 mol% n-hexane is flash distilled. F=150 kmol/h. Drum pressure =250 kPa, drum temperature =10 degrees celcius. use the depriester charts. find V/F, xi, yi, V, L.

Calculate the cost per piece of a milling operation : Calculate the cost per piece of a milling operation that is used to machine a pocket of 2”x3”x0.5” (LxWxD). The material being machined is high silicon aluminium. The tool material is PCD.

What is the thermal and mechanical efficiency : What is the thermal and mechanical efficiency for this engine when used as heat pump and refrigerator with the following propties;

Determine the power required to drive the pump : A water pump is required to pump 0.23ft3/sec of water at 60F at atm up to 100psi gage. of the pump has an estimated isentropic efficiency of 50%, determine the power required (HP) to drive the pump.

Calculate the entropy change of the two reservoirs : Heat in the amount of 100 kJ is transferred directly from a hot reservoir at 1200 K to a reservoir at 600 K. Calculate the entropy change of the two reservoirs and determine if the increase of entropy principle is satisfied.

User Account

All Pages