Does the transition depend on the size or shape of the grid

Assignment Help Electrical Engineering
Reference no: EM13262275

The BML traffic model is perhaps the simplest system exhibiting phase transitions and self-organization. Moreover, it is an underpinning to extensive modern studies of traffic flow. The general belief is that the system exhibits a sharp phase transition from free flowing to fully jammed, as a function of initial density of cars. The existence of this sharp transition has been cited in the scientific literature several hundreds of times.

Use your BML experiment to conduct a simulation study of the behavior of the BML model.

1. For what values of p, the density of the grid, did you find free flowing traffic and traffic jams? Did you find any cases of a mixture of jams and free flowing traffic?
2. How many simulation steps did you need to run before observing this behavior?
3. Does the transition depend on the size or shape of the grid?

To answer these questions, run the experiment for different values of the input parameters.For each set of input parameters that you examine, run the experiment multiple times tounderstand the variability in the process. For example, does a p = 0.8 always end in a traffic jam or does it only end in a traffic jam 70% of the time?

Reference no: EM13262275

Questions Cloud

Find the angular momentum of the sphere : A hollow, thin-walled sphere of mass 12.0kg and diameter 47.0cm is rotating about an axle through its center. At the time 4.00s , find the angular momentum of the sphere
Why are the valuations different : What should be the prices of the following preferred stocks if comparable securities yield 7 percent? Why are the valuations different?
Explain the required equipment and supplies : The assay for Xase has just been worked out, and you have a preparation of cells rich in this enzyme. Given the required equipment and supplies, how would you proceed
What is the operating cash flow : Your firm has net income of $322 on total sales of $1,300. Costs are $720 and depreciation is $120. The tax rate is 30 percent. The firm does not have interest expenses. What is the operating cash flow?
Does the transition depend on the size or shape of the grid : The general belief is that the system exhibits a sharp phase transition from free flowing to fully jammed, as a function of initial density of cars. The existence of this sharp transition has been cited in the scientific literature several hundred..
What is the change in net working capital : At the beginning of the year, a firm has current assets of $323 and current liabilities of $227. At the end of the year, the current assets are $483 and the current liabilities are $267. What is the change in net working capital?
What was the percentage increase per year in the winner : In 1895, the first a sporting event was held. The winner's prize money was $170. In 2007, the winner's check was $1,164,000.
How much work did the child do on the merry-go-round : A playground merry-go-round has radius 2.90m and moment of inertia 2500kg?m2 about a vertical axle through its center, and it turns with negligible friction. How much work did the child do on the merry-go-round
What is the price of the stock today : If the required return is 12 percent, what is the price of the stock today?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Describe what will happen on the circuit for present state

A. Make a two bit counter with The input X =0 makes the counter count from 0-3-1-0 and X=1 goes from 0-1-2-3-0. Choose two different types of flip flops to implement it. B. Describe what will happen on your circuit when the present state is 2 and ..

  What are two fundamental advances

what are two fundamental advances in the circuit theory that were developed in the 19th century in response to the challenges of telegraphy?

  What must the magnitude of the charge in micro coulombs

The space between the plates is then filled with a dielectric material, with dielectric constant k = 6.55. What must the magnitude of the charge in micro coulombs on each capacitor plate now be, to produce the same potential difference between the..

  Identify the required voltage levels and calculate currents

Design a power system for a facility, which requires both three phase and single phase supplies. Following conditions must be applied in the design: 1) The facility is at least 60 km far from a distribution substation.

  Examining an rf splitter and power levels

Analysing an RF splitter and power levels, A splitter is a device that has a single input and several outputs. It is used to send a signal to several different locations

  Derive an expression for the built-in voltage

Consider a p-type semiconductor substrate with Na =10^15 cm^-3. A region of heavily p+ doped material is formed by ion implantation as shown in the sketch below.Derive an expression for the built-in voltage under equilibrium conditions.

  Write a subroutine in assembly language to compute sum

Assume that the$% are signed 8-bit and stored in consecutive locations starting at$504020. Assume that A0 points to the s. Also, write the main program in 68000assembly language to perform all initializations (A0 to $504020, A7 to $406020)

  Determine the concentration of donor impurity atoms

A silicon sample at T = 300 K contains an acceptor impurity concentration of \(N_{A}\) = 1016 cm-3. Determine the concentration of donor impurity atoms that must be added so that the silicon is n-type and the Fermi energy is 0.20 eV

  Calculate the line parameters r-l-g and c

A two-wire copper transmission line is embedded in a dielectric material with εr = 2.6 and σ = 2X10-6 S/m. Its wires are sperated by 3 cm and their radii are 1mm each. Calculate the line parameters R', L', G', and C' at 2GHz.

  Describe the components and variables of biological control

a) Describe the components and variables of the biological control apparatus involved in walking toward an object that can be seen on the horizon b) Why is walking a closed-loop operation

  Calculate the inverse fourier transform

Compute the inverse Fourier transform for X(ω) = cos 4ω. 5. A signal with the highest frequency component at 10 kHz is to be sampled. To reconstruct the signal, the sampling must be done at a minimum frequency of?

  Find the stall current-max speed in rotations per minute

Find the stall current, max speed in rotations per minute (RPM), and armature current at a speed of 480.769 radian/s (4591.006 RPM). Discuss the relationship (if any) between the armature current at max speed

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd