User Account

All Pages

Diesel engine has a temperature

Assignment Help Mechanical Engineering
Reference no: EM13709243

A diesel engine has a temperature of 540R and a pressure of 30 psi at the beginning of compression.

After the heat addition process the temperature is 2600R and the pressure is 1000 psi.

Determine: USING VARIABLE SPECIFIC HEAT METHOD

1. The compression ratio of this engine

2. The net work of the cycle

3. The thermal efficiency of the cycle

Reference no: EM13709243

Questions Cloud

Does the client–user–designer model still apply : Suppose you are working for a start-up company that is designing a very new and innovative product. Does the client–user–designer model still apply? Who is your client in this case? Since you don’t have any customers yet, who are the users and how ca..
How much time do bo and luke spend in the air : Bo and Luke are running from Roscoe P. Coltrane and are going to jump the General Lee (their car) over the Hazard River. How much time do Bo and Luke spend in the air
Increase in the pressure exerted on the submarine : A submarine cruising 40 m below the free surface of seawater whose density is 1025 kg/m3. Calculate the increase in the pressure exerted on the submarine when it dives to a depth of 150 m below the free surface in kPa.
Find what is the dielectric constant of the material : Two capacitors have the same plate separation, but one has square plates and the other has circular plates. What is the dielectric constant kcircular of the material between the circular plates
Diesel engine has a temperature : A diesel engine has a temperature of 540R and a pressure of 30 psi at the beginning of compression. After the heat addition process the temperature is 2600R and the pressure is 1000 psi.
How far from the base of the table will it strike : A marble moving 1.48 m/s rolls off the top edge of a 125cm high table in a room where there is no appreciable air resistance and the acceleration due to gravity is 9.80 m/s2. How far from the base of the table will it strike
Actual operating cost-minimum theoretical operating cost : A heat pump with a coefficient of performance of 3.5 provides energy at an average rate of 70,000 kJ/h to maintain a building at 20C on a day when the outside temperature is -5C. If electricity costs 8.5 cents per kW*h
What is the minimum velocity with which ball must be thrown : A basketball player wants to know how fast the ball must be traveling when it leaves his hands to make it into the basket. What is the minimum velocity with which the ball must be thrown
Estimate what is the maximum height reached by the ball : A ball is thrown straight up with a speed of 30 m/a, and air resistance is negligible. What is the maximum height reached by the ball

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The bungee cord has an undeformed length of 350 ft what is

if a 150 lbf person wants to bungee jump from a bridge that is 400 feet above the surface of a river and the bungee

  Using the von mises failure criterion determine the maximum

a thin-walled cylindrical gas vessel has a mean radius of 3 ft and a wall thickness of 12 in. the yield stress of the

  A prismatic bar is subjected to loads that cause uniform

a prismatic bar is subjected to loads that cause uniform axial strains epsilon0.002 in its left half and epsilon-0.004

  An air pressure is to be measured relative to atmosphere

an air pressure is to be measured relative to atmosphere using an inclined manometer with a resolution of 1 mm and a

  The exit temperature of the water is 25oc then what is the

an adiabatic heat exchanger has 0.3 kgs of water passing through one flow path. the inlet temperature and pressure are

  Saturated liquid vapor mixture of water

0.65m^3 rigid vessel initially contains saturated liquid vapor mixture of water at 150C. The water is now heated until it reaches the critical state. Determine the mass of the liquid water and the volume occupied the liquid at the initial state.

  Coming out of a factory chimney are the following gases

coming out of a factory chimney are the following gases co2 so2 o2 n2 h2o with volume percentage to be 13.5 0.3 5.2 76

  Calculate the local atmospheric pressure in the city in kpa

1. write out the differences betweena close system and open systemgive one example and state what type of system it isb

  How long will it take to drain the tank completely if it is

you need to drain a cylindrical reservoir to fix a crack. a reservoir is 10m high and has a diameter of 5m. there is an

  Determine a the boundary work needed for this process and

a piston cylinder device contains 2.5 kg of carbon dioxide co2 initially at 100 kpa and 300 degrees celsius.the co2 is

  The water exits the chamber as a saturated liquid at the

liquid water at 50degc and 1 mpa is mixed with superheated steam at 200degc and 1 mpa in an open feedwater heater

  Compare the following characteristics of the two propellers

it is proposed to improve the takeoff performance of a single-engined aircraft fitted with a 50-in-diammeter propeller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd