Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Devise logic circuits using NAND/NOR logic that will provide the two alarms of given Problem.
ProblemA tank shown in given Figure has the following Boolean variables: flow rates, QA, QB, and QC; pressure, P; and level, L. All are high if the variable is high and low otherwise. Devise Boolean equations for two alarm conditions as follows:
a. OV = overfill alarm
1. If either input flow rate is high while the output flow rate is low, the pressure is low and the level is high.
2. [If both input flow rates are high while the output flow rate is low and the pressure is low.]
b. EP = empty alarm
1. If both input flow rates are low, the level is low and the output flow rate is high.
2. If either input flow rate is low, the output flow rate is high and the pressure is high.
An incandescent lightbulb rated at 60 W will dissipate 60 W as heat and light when connected across a 100-V ideal voltage source. A 100-W bulb will dissipate 100 W when connected across the same source.
What is the inductive reactance? What is the impedance of the circuit? What is the circuit's time constant? Assume that there is another resistor R2 in series with R1, What should be the value of R2 if the time constant is 10 milliseconds?
For a current flowing on a sheet, how would you define the current density at a point on the sheet? What are the units?
If a signal plus noise is fed into a linear device, show that the noise figure of that device is given by F = (S/N)in(S/N)out (Hint: Start with the basic definition of noise figure that is given in this chapter.)
Find the initial voltage across the capacitor at t = 0.- Write an equation for the voltage across the elements for t > 0. Do not solve it.
First-order Euler method for an ODE. Consider using the first-order Euler method for the solution of Equation (3.31). Find and plot solutions for ?t = 0.1τ , 2.0τ , and 2.5τ and compare your numerical results with the exact solution. Your plots sh..
Consider the current it takes to power a +5V 74xx245(Icc). What is the qualitative difference between the CMOS devices and the non-CMOS devices and the non-CMOS devices What is the explanation for the difference
Calculate the optimum receiver temperature using Eq. (9.10) under reasonable assumptions.
Given a silicon diode with a reverse current of 5 a at 25°C and 100 μA at 100°C, calculate the surface leakage current.
Find the expression for the total equivalent capacitance for an array of n capacitors with arbitrary capacitance C1,C2,...,Cn; when they are connected a) inseries and b) in parallel.
Design a combinational circuit that converts a 4-bit gray code to a4-bit binary number. Implement the circuit with exclusive-OR gates.
A three-phase, 318.75-kVA, 2300-V alternator has an armature resistance of 0.35 /phase and a synchronous reactance of 1.2 /phase. Determine the no-load line-to-line generated voltage and the voltage regulation
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd