Develop a program to perform the analysis appearing

Assignment Help Electrical Engineering
Reference no: EM131206227

Using the results of given problem, develop a program to perform the analysis appearing in Example (b) for cast steel. A test routine will have to be developed to determine whether the results obtained are sufficiently close to the applied ampere-turns.

Problem

Note how closely the B-H curve of cast steel in given Figure matches the curve for the voltage across a capacitor as it charges from zero volts to its final value.

a. Using the equation for the charging voltage as a guide, write an equation for B as a function of H = [B f(H)] for cast steel.

b. Test the resulting equation at H 900 At/m, 1800 At/m, and 2700 At/m.

c. Using the equation of part (a), derive an equation for H in terms of B [H = f(B)].

d. Test the resulting equation at B = 1 T and B = 1.4 T.

e. Using the result of part (c), perform the analysis of Example 11.3, and compare the results for the current I.

1396_Figure.jpg

EXAMPLE a

For the series magnetic circuit of Fig. example (a)

a. Find the value of I required to develop a magnetic flux of  = 4 x 10-4 Wb.

b. Determine µ and µr for the material under these conditions.

751_Example a.jpg

EXAMPLE b

Find the magnetic flux  for the series magnetic circuit of Fig. example (b) for the specified impressed mmf.

310_Example b.jpg

Reference no: EM131206227

Questions Cloud

Find the induced voltage across a inductor : Find the induced voltage across a 50-mH inductor if the current through the coil changes at a rate of 0.1 mA/µs.
Estimate mean standard deviation coefficient of variation : Obtain the empirical distribution function and the Nelson-Aalen estimate of the dis­ tribution function for the time to surrender using Data Set D1. Assume that the surrender time is known for those who die.
What was the general sequence of events : Who was Pope'/Po'pay? What was his history and why was he important? How did the revolt go? What was the general sequence of events? How long did the revolts keep the Spanish out?
Calculate paul monthly claim under : 1. Calculate Paul's monthly claim under his income protection insurance cover if he decides not to take up the offer to return to work on a part-time basis.
Develop a program to perform the analysis appearing : Using the results of given problem, develop a program to perform the analysis appearing in Example (b) for cast steel.
Who have no identifiable living descendants : ANTHROPOLOGY 1510 - THE WAYS OF HUMANKIND: AN ANTHROPOLOGICAL PERSPECTIVE" SPRING 2016 - Consider the issues at hand and post a statement of your thoughts on it. Should human remains be left alone entirely? Is it acceptable to excavate and study th..
Give an algorithm that takes n lines as input : Give an algorithm that takes n lines as input and in O(n log n) time returns all of the ones that are visible. Figure 5.10 gives an example
Calculate net income : Presented below are changes in the account balances of Al-Othman Company during the year, except for Retained Earnings. The only entries in Retained Earnings were for net income and dividends. Al-Othman declared dividends of $8,250 and paid divide..
What challenges does such a brand recall rate present : Why was it logical for UPS to have four different marketing approaches? How important is a brand recall rate of 97% to 98% for UPS? What challenges does such a brand recall rate present to competitors?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the current i1 required to establish a flux

Determine the current I1 required to establish a flux of 2 x 10-4 Wb in the magnetic circuit of given figure.

  Calculate the instantaneous power absorbed by the resistor

A voltage v(t) = 359.3 cos(wt) is applied to a load consisting of a 10 resistor in parallel with a capacitive reactance XC = 25. Calculate The instantaneous power absorbed by the resistor The instantaneous power absorbed by the capacitor

  What is the difference in the filtered signals spectrum

A signal contains a mixture 30 , 100 and 240 Hz Sine waves and also contains wideband noise whose spectrum is from 500 Hz up to a 1000 Hz. Describe a filtering technique that can be used to cleanly separate 30, 100 and 240 Hz from each other and a..

  What is the output when the input is 5a in hexadecimal

An 8-bit DAC outputs a value of 9.961 V when the input is FF (hexadecimal). What is the output when the input is 5A (hexadecimal)

  Design an op-amp amplifier circuit

Design an op-amp amplifier circuit where the smallest resistor available is 10k . The circuit must yield the relationships shown in the following equation: Vout = 8v1 + 8v2 - 4va - 9vb

  Calculate the power supplied to the 3-phase load

Three resistors are connected in delta. If the line voltage is 13.2 kV and the line current is 102.2 A, calculate the following: a. The current in each resistor. b. The voltage across each resistor. c. The power supplied to each resistor.

  How much power is dissipated by a resistor in series

(1) How much power is dissipated by a 2.4 k resistor in series with a 12V power supply (2) Determine the result of dividing the squares of 12V by 3.3 k ohms.

  Derive an expression for ratio of proportionality constants

Derive an expression for the ratio of the proportionality constants and plot the distribution of the m = 0 TE mode for a slab waveguide with parameters

  Compute current in the element voltage across element

The charge entering the + terminal of an element is q(t) =-12e^-2t mC. if the power delivered to the element is p(t) =2.4e^-3t W. Compute the current in the element, the voltage acrossthe element and the energy delivered to the element in the time..

  Determine the turns ratio of each transformer and current

Three single-phase transformer are used to form a three-phase transformer bank rated  13.8kV(delta)/120kV(wye). One side is connected to a three-phase load of 12 MVA at 0.8 power factor lagging. Determine the turns ratio of each transformer

  Determine the following number of quantization levels

Assuming that a 8-bit ADC channel accepts analog input ranging from 2.5 to 2.5 volts, determine the following:

  Show the construction of an asynchronous mod 2 counter

show the construction of an asynchronous MOD 2 binary up/down counter withup/down counter control P, when P= 0, it counts up and, when P= 1,it counts downs.use JK flip-flop.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd