Determine what value of c will be needed to produce wo

Assignment Help Electrical Engineering
Reference no: EM13286158

a 20 mH inductor with an internal resistance of 20 ohms is connected in series with a capacitor and a voltage source with a thevenin resistance of 60 ohms.
a. what value of C will be needed to produce Wo = 6 krad/s
b. find the bandwidth and quality factor of the circuit

Reference no: EM13286158

Questions Cloud

What is the potential drop across capacitor : Three capacitors with capacitances C1 = 2.9 nF, C2 = 3.1 nF, and C3 = 1.7 nF are wired to a battery with V = 14.3 V, What is the potential drop across capacitor 2
Define empirical formula for an oxide of chromium : An experiment was carried out similar to the one carried out to determine the empirical formula of magnesium oxide. The empirical formula for an oxide of chromium is required
Determine the magnitude of the magnetic field at r : The current density in a cylindrical conductor of radius R = 43.1 cm, varies as J(r) = J0r/R (in the region from zero to R), where J0 = 0.417 C/m2. a) Find the magnitude of the magnetic field at r = 21.55 cm.
Find the intensity level in decibels at that distance : An outside loudspeaker (considered a small source) emits sound waves with a power output of 120 W. Find the intensity level in decibels at that distance
Determine what value of c will be needed to produce wo : a 20 mH inductor with an internal resistance of 20 ohms is connected in series with a capacitor and a voltage source with a thevenin resistance of 60 ohms. a. what value of C will be needed to produce Wo = 6 krad/s
Explain the concentration of hconh2 be at equilibrium : Consider the reaction COg) + NH3=HCONH2, Kc=0.800. If a reaction vessel initially contains only CO and NH3 at concentrations of 1.00 M &2.00M, respectively, what will the concentration of HCONH2 be at equilibrium
Find the direction of the velocity of the plane : The pilot of an airplane notes that the compass indicates a heading of due west. find direction (measured from west) of the velocity of the plane relative to the ground
Determine l-c-q and the two cut off frequencies : a series RLC bandpass circuit with R= 30 ohms is designed to have a bandwidth of 5 Mrad/s and a center frequency of 50 Mrad/s. Find L, C,Q and the two cut off frequencies.
What would be the money multiplier and the maximum amount : The BASIC financial system has a required reserves ratio of 15%; initial reserves are $5 million, cash held by the public is $1 million and is expected to stay at that level, and there are no toher leakages or adjustments in the system.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Design a synchronous sequential circuit with one input line

Design a synchronous sequential circuit with one input line and one output line that recognizes the input string x = 1111. The circuit is also required to recognize overlapping sequence such that if the input string is x = 1101111111010

  Find a boolean equation describing the required alarm output

The variables are provided as high (1) and low (0) levels for digital control. An alarm should be initiated whenever any of the following occur: a. Speed is low; both weight and loading rate are high.

  Find after how many days of operation penalty billing covers

An industrial assembly hall is continuously lighted by one hundred 40- W mercury vapor lamps supplied by a 120- V and 60- Hz source with a power factor of 0.65. Due to the low power factor, a 25 percent penalty is applied at billing.

  What is the piv rating for the diode

A 3.3V, 30 A dc power supply is to be designed with a ripple of less than 2.5%. Assume that a half-wave rectifier circuit (60 Hz) with a capacitor filter is used.

  Find receiving power of mobile phone a and mobile phone b

The mobile phone used has effective area of 3m^2 and good signal reception required receiving power of 1mW. -Calculate the receiving power of mobile phone A and mobile phone B. -Which mobile phone has good coverage

  Find the commutators frequencies in rotations per second

The data rate of m4(t) is 16 kbps and m5(t) is 16 kbps too. The analog signals are to be sampled at rates no less than their respective Nyquist rates, then converted to the PCM format with 4 bits for each sample. 1.Suggest a suitable multiplexing s..

  Find the input power to the generator in horsepower nd watts

A 500-kVA, 60Hz, 5000V, Y-connected, 10 pole synchronous has internal parameters of Armature Resistance 1ohm amd Synchronous Reactance 10ohms. The generator is operating at rated values and 0.9 pf leading.

  Differential amplifier with thermocouple

What are the essential features of an ideal op amp? Identify the terminals of an op amp. Draw its equivalent circuit. Define virtual ground and what is difference amplifier? Draw its circuit. Define C.M.R.R.

  Calculate the sacrifice ratio

Inflation in years 1-5 equals 3.1 percent, 2.2 percent, 1.6 percent, 1.3 percent, and 1.1 percent, respectively.

  Prove that the electrons will not reach the positive plate

Electrons are liberated with zero velocity from the negative plate of a parallel plate capacitor, to which is applied a magnetic flux density B parallel to the plates. Prove that these electrons will not reach the positive plate.

  Find resolution of the fourier transform if signal is sample

what is the range of sampling frequencies you can use such that you don't violate Nyquist theorem and still meet or exceed the needed resolution when you perform the FFT operation on the full set of collected data

  What are the electric and magentic fields in materical

An x-y plane separates two materials. Material 1 covers z 0 region. There is no surface current or charge on the boundary between the two materials.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd