Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
If you have 1024 samples of a discrete-time band-limited signal sampled at a rate of 100MHz. what is the time period between samples? If you take a 2048 point FFT of the sampled signal, what will be the freuqency spacing between the output samples ?
A parking garage charges a $ 5.00 minimum fee to park for up to three hours and an additional $ 1.00 per hour for each hour over the hours. the maximum charge for any given 24 hours period is $ 2.00.
Deer ticks can carry both Lyme disease (L) and human granulocytic ehrlichiosis (H). In a study of ticks in the Midwest, it was found that 16% carried L, 10% carried H and 25% that had either L or H carried both.
compute the diameter in centimeters of a steel rod, an aluminum rod, and a copper rod, which can withstand a particular compression load.
Suppose your multimeter is fused for 300 mA. You want to measure current through a resistor via a 9-volt battery. What is the minimum resistance such that the current is less than 150 mA
Write a program to generate a 25-Hz digital waveform with a 50 percent duty cycle on the PT0 pin as long as the voltage level on the PP7 pin is high. Your program should consist of two parts: Entry test. As long as the PP7 pin is low, it stays in t..
Make a sketch of the band diagram for an n-type semiconductor and a p-type semiconductor doped with phosphorus and boron at 5*10^15/cm^3 respectively. Label all the features of your drawing, as well as the relative energy
A common energy consumption for a family is about 1000 kW hr / month. How much power would that be on the average. (Hint: Notice that hour and month are both units of time so kW hr per month is really a power unit.
A buck converter has the following parameters: Vs = 24 V, D = 0.65, L = 25 uH, C = 15 uF, and R=10 ohm.The switching frequency is 100 kHz. Determine (a) the output voltage, (b) the maximum and minimum inductor currents
Write the VHDL architecture file for a J-K flip-flop that toggles on each falling clock edge. Use J and K for the inputs, Q for the output, and CLK for the clock. All signals are BIT type.
Design a circuit that takes the output from each of the five microphones your band uses and adds the voltage to create a single voltage signal which is fed to the amplifer. Except not all voltages should be equaly amplified.
With a 500hp shunt wound DC motor, at 1800rpm, 500Vdc, FLA is 800Adc, Ra is 0.025 and Rf is 400. What would Va need to be if you wanted the motor to operate at 1000rpm at rated torque. Keeping the field current constant.
1) What is the difference between a continuous spectrum and a line spectrum 2) What is the fundamental difference between a continuous signal and a discrete signal 3) Why are linear time invariant (LTI) systems so important in engineering and enginee..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd