Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A windmill park produces energy at a tension level of 11kV. The park is going to be coupled up with a 11kV net not far from the park. To reduce the loss in transer the tension is tranfomred p at the parka nd down again right before coupling to the 11 kV net. The losses in the transfer reduces by a degree of 8/9 in relation to 11kV. What is the tension level of the transfer line?
You are planning to buy a $250,000 house and will take out a mortgage for 80% of the homes value. The term of your mortgage is 15 years and the interest rate is 4%, compounded monthly.
The circuit should stay idle with low output, when the button (B) is not pushed (not asserted).Draw the state diagram, and circuit logic diagram. Use minimal number of external gates. [Hint: Use positive edge triggered D flip-flops]
If you have 16 kibibytes of memory plus a few (less than 10) memory mapped devices (assume that each device uses 16 bytes of address space), what should the address size be
Consider a 6 cm2 dye sensitised solar cell with reverse saturation current Jr=10-10A/cm2. When the solar irradiance is 1,000 W/m2, it produces an equivalent photo current/short circuit current of 15 mA/cm2 at 300 K.
Create a bandpass filter with cutoff frequencies of 100-1k, attenuate by at least 3db at desired frequency(100-1k) and at 60Hz attenuate by 10 db. Resistor, Capacitor, Inductor, and Op-amps can be used.
A car with a projected frontal area of 1.8 m^2 is traveling at 136 KPH. If the drag coefficient of the car is 0.45 and the air density is 1.23 kg/m^3, find the total aerodynamic drag force on the car, and the power required to overcome this drag f..
A cold heading operation is performed to produce the head on a steel nail. The strength coefficient for this steel is 600 MPa, and the strain hardening exponent is .22. Coefficient of friction at the die-work interface is .14.
Let y(t) he the signal at the output of the LTI system when x(t) is the input signal. The following signals are sampled using a train of impulses with periodicity T, signal x(t) is sampled to obtain xc(t), and signal y(t) is sampled to obtain yc(t..
Design a combinational logic circuit which has one output Z and a 4-bit input ABCD representing a binary number. Z should be 1 iff the input is at least 5, but is no greater than 11. Use one OR gate (three inputs) and three AND gates
The steering wheel of a car has a radius of 0.11 m, while the steering wheel of a truck has a radius of 0.28 m. The same force is applied in the same direction to each. What is the ratio of the torque produced by this force
Why developing software for wireless devices is challenging? List and briefly describe the two (2) reasons given in your textbook for why developing software for wireless devices is challenging.
As speed increases, the lower lamp, L1 lights, then L1 and L2, then, L1, L2, and L3, until all lamps light at the highest speed. Once all the lamps illuminate, no further increase in speed will have any effect on the display.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd