Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An ideal inverting operational amplifier is configured for a negative feedback loop such that Rf and Rin are equal in magnitude. Vin is a +10 V DC voltage source. A second DC voltage source is connected directly to the positive input terminal of the op amp, so that both input terminals are maintained at +5 V. What is the output of the operational amplifier?
The length of a wire of a potentiometer is 100 cm, and the e.m.f. of its stand and cell is E volt. It is employed to measure the e.m.f. of a battery whose internal resistance is 0.5 ohm. If the balance point is obtained at l =3..
A 37.5-kVA, 6900-230V, 60Hz, single phase transformer is operating in the step down mode at rated load, rated voltage, and 0.68 power factor lagging. The equivalent resistance and reactance referred to the low side are 0.0224Ω and 0.0876Ω
The magnitude of the current in a RL circuit decreases at a rate of 2000 A/s at t=0 and 100 A/s at t=.2s. At what time has the energy stored in the inductor decreased 1 percent of its intial value.
A 200 ft length of solid copper wire is measured to have a resistance of .500 Ohms. a. Determine the cross sectional area of the wire in both square mils and in circular mils. b. Determine the diameter of the wire in mils and in inches.
The silicon cube you were shown consisted of 4x4x4 unit cells. You were shown one dopant in the silicon cube. Given that the lattice constant of silicon is 0.543 nm. Calculate the dopant density represented by the 4x4x4 silicon cube simulation.
What is the difference between the saturation and active regions of a BJT. What determines which region the transistor is in.
Determine the minimum bandwidth required to achieve a P(e) of 10^-4 for a 16-PSK system operating at 25 Mbps with a carrier-to-noise ratio of 10 dB
The thickness variation must be within ±10% across the substrate. Your evaporation chamber consists of two sources separated by a distance D and the substrate is at a height h from the sources.
A three resistors connected in series with a DC power supply of 12 volts with a return path to the negative terminal of the power supply also connected to ground. The first resistor is labeled "R1", which is equal to 220 Ohms.
in a given byte-addressable computer, memory location 10000Hto 9FFFFH are avaliable for user programs. the first location is 10000H and the last location is 9FFFFH. calculate the following: the total number of bytes available (in decimal)
A tollgate (vending machine) controller accepts only nickels (5c), dimes (10c), and quarts (25c), and generates control signal to actuate the lever to open the tollgate (or dispense a chosen item in case of vending machine) once 35c or more are re..
Assume you buy a 1 kOhm resistor with +/- 20% tolerance in its value. You would like this resistor to consume at most 2 W of power, otherwise it might burn. What is the highest power supply in V you would use to power it
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd