Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 30hp 3 phase 360v 60 Hz induction motor has total internal losses of 2,500 watts when operating at full load. What is the motor's full load efficiency?
constructed using standard value resistors a. Without making a single calculation, which resistive element will have the most voltage across it Which will have the least b. Which resistor will have the most impact on the total resistance.
Identify one emerging technology, and evaluate its future prospects by identifying the cultural and social factors that may prevent or promote its successful application. Use concrete details to support your answer.
Two data streams are coming serially to a system. These two streams are carefully observed and if considering any three bits from each stream, we observe that these two input streams are equal ; the FSM gives a signal to an alarm system.
A MOSFET transistor is being used as a converter switch in a 100v system. It is switching at 50 KHz and has a linear transition time of 3us. The full load current is 40 amps. - How much average power is being wasted due to switching
What is the quantization signal to noise ratio SNRQ at the receiver output? e. If the SNRQ were to be raised to 96 dB, how many bits would the ADC and DAC need? What would be the bit rate on the serial link?
a meter stick of uniform mass distribution and a mass of 0.150-kg is arranged as follows; a fulcrum is placed under the stick at the 20-cm mark on the stick. A mass of 0.100-kg is suspended from the 90-cm mark.
1. Point charges Q1 and Q2 are respectively, located at(4,0,-3) AND (2,0,1). If Q2=4nC, find Q1 such that a. E at (5,0,6) has no no z component b. The force on a test charge at (5,0,6) has no x component
An additional variable power factor load is to be added to the factory. The new load will add 320kW to the factory. The power factor of the variable factor load is to be adjusted so that the overall power factor of the factory is 0.96 lagging.
The prime mover rotates the armature at a speed of 1000 rpm. Determine the no-load voltage, the full-load voltage, and the torque required by the prime mover at full load if the full-load power required by the load is 3 kW
A three-phase load is Y-connected. The load has a phase voltage of 139 V and a phase current of 49 A. Each phase of the load consumes 5.1 kW of power. (A) Sketch and label the load. Find (b) the line voltage, (c) the line current, and
A 150-MVA 15/200-kV single-phase power transformer has a 0.018ohm resistance and a 0.075ohm reactance. The magnetizing impedance is j80 per unit. a.) Find the equivalent circuit referred to the low-voltage side of this transformer.
Design a combinational circuit with four inputs, x,y,w, and z, and four outputs: A, B, C, and D. When the binary input value in decimal is 3,5,6,9,10 or 12, the binary output value is one less than the input value, otherwise it is one greater than..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd