Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A sinusoidal signal with frequency known to be less than 1 kHz is sampled at 600 Hz. and appears as a 150 Hz signal. The sample rate is changed to 550 Hz, and the apparent frequency of the sampled signal shifts to 100 Hz. What is the frequency of the analog signal?
What are the transfer function and the impulse response of the system?
Design a voltage regulator circuit that provide a voltage at a maximum of 100 mA from a 6V battery. A maximum of 1W of power should be dissipated in any one component.
Using data from the data sheets of the MAX505 DAC, and the various temperature coefficient of DAC errors specified at 25 degrees Centigrade, calculate the total Worst Case Error for a temperature deviation of 45 degrees Centigrade.
You have a laundry room where the following loads are connected to a 208V circuit: 2500W electric base board heater, 600W wash machine, 3600W dryer, and a 1000W iron. All loads are connected in parallel.
(Probability of negative lifetime is negligible) Lifetime of chip 2 is also a Gaussian RV with mean 22,000 and standard deviation 1000 hours. Which is preferred if the target lifetime of the system is (i) 20,000 hours and (ii) 24,000 hours
The main mission of this project is to design and build a tap changer which is going to be fitted to power transformers for regulation of the output voltage to required levels for the Micro Grid. The tap changer system will consist of 9 changers with..
A block error detecting code has a minimum distance of three. How many errors can this code detect and how many can it correct
A stepper motor is being used to move a crane. The motor has the following properties: Holding torque = 2 m.kg, dynamic torque = 1.5 m.kg, and detent torque = 0.5 m.kg. Through a 1:5 gear, the motor (motor connected to the smaller gear)
A 10 H inductor is connected in series with a 1.0k(ohm) resistor and a switch which closes at t=0s, Determine the voltage across the inductor and the current through the inductor for t>0 if the inductor has an initial current of 10 A.
Polonium (Po) is the only material which forms a simple cubic crystal (i.e., it is not FCC or BCC) structure with atoms at the corner positions. It is a metal (but it is radioactive so it has very few engineering applications!). Its atomic number ..
where fc is the carrier frequency, Ac is the carrier amplitude, µ is the modulation index, and x(t) is the baseband message signal. We assume that x(t) has absolute bandwidth W
The following test data were taken on a 110-KVA, 4400/440- volt, 60-Hz transformer: Short Circuit Test: P= 2000w, I = 200 amp, V = 18v Open Circuit Test: P=1200w, I= 2 amp, V = 4400v Calculate the voltage regulation of this transformer when it suppli..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd