Determine what is the eirp in watts and dbm

Assignment Help Electrical Engineering
Reference no: EM13290537

A system has a powe gain of 52. Directivity is measured as 90 and the dissipated power in an antenna with a gain of 700 is 1.9 watts. what is the EIRP in watts and dBm?

Reference no: EM13290537

Questions Cloud

Draw a graph of v=ir : Draw a graph of V=IR for R=300ohms over the domain -3mA
Find noise power-noise current and equivalent noise voltage : A device operates at 30 degree C with a bandwidth of 8 KHz anda dccurrent of 1.75 ma. Find the total noise power, moise current and equivalent noise voltage.
State the molar mass of a monoprotic acid : Why is it not possible for the molar mass of a monoprotic acid to have a value less than 1g/mol
What is the number of this next-highest harmonic : One of the harmonic frequencies of tube A with two open ends is 1020 Hz. The next-highest harmonic frequency is 1088 Hz. What is the number of this next-highest harmonic
Determine what is the eirp in watts and dbm : A system has a powe gain of 52. Directivity is measured as 90 and the dissipated power in an antenna with a gain of 700 is 1.9 watts. what is the EIRP in watts and dBm
Difference between beneficence and nonmaleficence : What is the difference between beneficence and nonmaleficence? Give examples of each from your clinical practice.
Explain how many moles of of aluminum chloride : You are given 10.0 of aluminum and 15.0 of chlorine gas. Part A If you had excess chlorine, how many moles of of aluminum chloride could be produced from 10.0 of aluminum
Find the average acceleration vector of the football : As a function of time, the velocity of the football can be written as . (If the acceleration of an object is constant, find the average acceleration vector of the football
Layered security approach to system administration : When using a layered security approach to system administration, who would have the highest access privileges?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the irradiance of the filament

A coiled tungsten wire of diameter 50um and length 10cm is glowing at a temperature of 2000°C within an evacuated light bulb. Determine the irradiance of the filament and the fraction of irradiance within the visible range of wavelength.

  Find values of external resistors for astable multivibrator

determine the values of the external resistors for a 555 timer used as an astable multivibrator with an output frequency of 2 kHz, if the external capacitor C is 3.0 mf and the duty cycle is to be approximately 75%

  What is the maximum allowable value of r2

For the amplifier in Fig. P4.20, the maximum value of VS is 2 V and the op-amp can deliver no more than 100 mA. (a) If +-10 V supplies are used, what is the maximum allowable value of R2 (b) Repeat for +-3 V supplies.

  Design appropriate amplifier needed to maintain the signal

the hd cable signal send out is usually ranging between (1-25mv), with the frequency range from 1000Hz- 20Khz. An amplifier will gain 46 db will boost the signal before sending it through the cable connection.

  What is the step response equation for charge time

1. What is the step response equation for charge time 2. How to determine the current in RLC circuit using the osciscope 3. List three reseasons why the measured value and pspice value for tau are different.

  How much electric flux leaves the surface of a sphere

A point charge of 20 [nC] is located at (4,-1,3), and a uniform line charge of -25[nC/m] lies along the intersection of the planes x=-4 and z=6. (a) Calculate D at (3,-1,0). (b) How much electric flux leaves the surface of a sphere of radius 5, ce..

  What is the magnitude of the force to support a bridge

illustrates how the forces can vary in problems of this type. A hiker, who weighs 739 N, is strolling through the woods and crosses a small horizontal bridge. The bridge is uniform, weighs 3250 N, and rests on two concrete supports

  What are the link length limits due to power and dispersion

A 1 Gb/s optical link is to be operated at the 1.55 m wavelength. Suppose the dispersion at the 1.55 m wavelength is 17 ps/km-nm, and the attenuation is 0.2 dB/km. For achieving a desired error probability, we are given that the receiver requires ..

  Calculate the bandwidth of the closed-loop transfer function

In a feedback system, the forward path has a transfer function of the form G(s)=k/(1+s/Omega_p) and the feedback path has a gain of k_fb which is less than unity. Calculate the bandwidth of the closed-loop transfer function

  Determine what is the internal resistance of the source

A short circuit across a current source draws 15 A. If a 10resistor across the source draws 13 A. What is the internal resistance of the source

  Find the electric field produced by the two rods

Two thin rods of length L lie on the x axis. One of them has a charge of -Q uniformly distributed along its length and is positioned between x = -L and x = 0. The other one has a charge of +Q uniformly distributed along its length.

  Find the final speed of the puck b and a after the collision

Hockey puck B rests on a smooth ice surface and is struck by a second puck A, which has the same mass. Puck A is initially traveling at 14.6 and is deflected 28.0 from its initial direction. Assume that the collision is perfectly elastic.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd