Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A square coil with sides of length 0.5m and of 100 turns of wire isplaced in a region with uniform magnetic flux density of 0.2T. If the maximum magnetictorque exerted on the coil is 4x10^-2 Nm , what is thecurrent flowing in the coil?
A high-pass filter with C=30pF. R= 40 kohm A) What is the cutoff frequency The output of this filter is connected to an amplifier with an input resistance of 60 kohm. B) Sketch and label the new circuit. C) What is the new cutoff frequency
If an excess of holes is introduced into the center describe in words (and what a sketch would look like) of the minority carrier distribution after a time roughly about equal to the minority carrier lifetime
a)Design the corresponding scrambler. b)Design the corresponding descrambler. c)Determine the output sequence T. d)Verify that if this T is applied to the input of the descrambler, the output is the sequence S.
Build a C++ code for vehicle sensing device. Code is required to embed in the device so that then it must sense the location where the vehicle is currently present. The device must be able to track the location of the vehicle for its owner
Explain the operation of sequential logic devices and evaluate the output waveform in relation to the clock for QA, QB and QC in the subsequent circuit and show the binary sequence represented by these waveforms
The electric motors unmanned drones use transformers to produce sufficient current to move the flight surfaces. Due to the weight restrictions of the vehicle, the transformers use a ceramic rather than iron, the ceramic has a permeability of mu = 4..
A second-order control system has the closed-loop transfer function T(s)=Y(s)/R(s). The system specifications for a step input follow. Show the permissible area for the poles of T(s) in order to achieve the desired response.
Experiment by changing the amplitudes of the modulating tones, and by adding a third tone to the modulating signal. First establish what you expect , then confirm by computer simulation.
Determine the service overcurrent protection device rating and undergrounded and grounded service conductor size. Use XHHW copper conductor and 75oC device terminal ratings and allow for 25% load growth. Do not use larger than 600 kcmil conductor ..
The Karina Light Company manufactures inexpensive light-emitting diode (LED) bulbs whose estimated lifetime in normal distribution with a mean of 9000 hours and a standard deviation of 500 hours. Calculate the probability that the LED will fail wit..
suppose that in the fluid-low analogy for an electrical circuit analog of electrical currentis volumetric flow rate with units of cm^3/s. For a proper analogy to electrical ciruits, must the fluid be compressible or incompressible
A HCS12 ATD is set to 8-bit unsigned mode. A temperature sensor measuring 0 to 100 degrees with an output of 25 mV/degree is attached to the input. The ATD low voltage reference is attached to ground and the high voltage reference
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd