Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In a MOS cascode amplifier, the cascode transistor is required to raise the output resistance by a factor of 40. If the transistor is operated at Vov = 0.2 V, what must its Va be? If the process technology specifies V'a as 5 V/um, what channel length must the transistor have?
The frequencies of the tones are 100 Hz, 300 Hz, and 450 Hz. The sampling rate is 1 kHz. Describe a low pass, a band pass, and a high pass filter that could be used to detect the individual tones.
a. What is the memory layout of the 16-bit value, 0x7654 in a big-endian 16-bit machine, and a little-endian 16-bit machine b. What would the layouts be in 32-bit machines
A single-phase 240/120 V transformer has the following parameters: R1 = 1 ohm, R2 = 0.5 ohms, X1 = 6 ohms, X2 = 2 ohms, Ro = 500 ohms & Xo = 1.5k ohms. (a) Load voltage referred to the primary side (b) Currents of the primary and secondary windings
A combinational logic circuit has 3 outputs as described below: F1=Minterm(0,3,4) F2= minterm(1,2,7) F3= Maxterm=(0,1,2,4) Implement the circuit using a single decorder with active high outputs and external 2 input OR gates
A 10 microFarad capacitor is in series with a 100 ohm resistor, a switch, and a 10.0 volt battery. At time t = 0 seconds the switch is closed. What is the current in the resistor at time t = 0.1 microseconds. What is the current in the resistor at ti..
A coaxial air line has an inner conductor diameter of 2mm and the inner diameter of the outer conductor is 4.6mm. A voltage of 1 V is applied to the inner conductor. Determine the surface charge densities on the inner conductor
I have a 3.6V battery, a shottky diode with a voltage drop of 0.22V, and an LED rated at 3V and 100mA. How much resistance will I need. Do i subtract battery voltage - LED voltage and divide by current desired
Calculate the Fourier Transform of f(t) = 5 sinc(-2t/100), and graph the magnitude and phase as a function of f. If the signal of problem 1 is delayed by 0.1 ms. What is the new Fourier Transform.
A HCS12 ATD is set to 8-bit unsigned mode. A temperature sensor measuring 0 to 100 degrees with an output of 25 mV/degree is attached to the input. The ATD low voltage reference is attached to ground and the high voltage reference
What resistance must be connected in series with a heater rated at 150mA with hot resistance of 320 ohm in order to operate it safely from a 117-V source. What power rating must this resistor have
A six pole, 400 V d.c. motor draws 110 A from the supply. The shunt field resistance is 200 Ohm and the armature resistance is 0.5 Ohm. The armature is wave wound with 600 conductors operates at a speed of 1200 rev/min when supplying full load.
Signal Definitions are A.H, B.L ,C.L, D.H and Z.L. It is recommended you apply DeMorgan's Theorem first to the above equation. Draw (on paper) a circuit diagram implementing Z, using the minimum number of gates.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd