Determine the velocity of the center of mass of the system

Assignment Help Physics
Reference no: EM13337478

A 1800 kg car is moving westward with a speed of 26 m/s, and a 2900 kg truck is traveling east with a speed of 14 m/s. Find the velocity of the center of mass of the system. (Take east to be the positive x direction.)

Reference no: EM13337478

Questions Cloud

Find the magnitude of the torque generated about pivot point : A force of 17 N is applied to the end of a 0.63 m long torque wrench at an angle 45° from a line joining the pivot point to the handle
Indvidual tax return problem : Complete Phillip and Claire Dunphy's 2012 federal income tax return. If information is missing, use reasonable assumptions to fill in the gaps
Evaluate the change in energy required : Calculate the change in energy required in making 70.0 mL of water from its elements under standard conditions
Specify the direction in which the bea is deflected : An electron beam contains electrons that move along the +x-axis at 0.020c. The beam enters a region of length 1.0 m and runs parallel to a wire that carries a 0.20-A current in the +x-direction.
Determine the velocity of the center of mass of the system : A 1800 kg car is moving westward with a speed of 26 m/s, and a 2900 kg truck is traveling east with a speed of 14 m/s. Find the velocity of the center of mass of the system
Find the speed of electron at its point of closest approach : The electron is heading at a 45 angle directly toward the wire when it is 50cm away; the electron reaches only as close as 1.0 cm, before being repelled away, always moving in the same plane. If the electron has an initail speed of 3.4 x 10^6 m/s,
The law of increasing cost would still apply : On the production possibilities frontier graph, the closer the economy's production is to the origin of the graph and the farther away it is from the PPF.
Explain what volume did the gas have : A scientist has a sample of gas that was collected several days earlier. The sample has a volume of 392 cm3 at a pressure of 0.987 atm and a temperature of 21°C. On the day the gas was collected, the temperature was 13°C and the pressure was 0.992..
Schedule the intangible section of lewiss balance sheet : Prepare a schedule the intangible section of Lewiss balance sheet at December 31, 2011. Show supporting computations in good form.

Reviews

Write a Review

Physics Questions & Answers

  What is the velocity of the crate at the bottom of the ramp

A man takes his dog out for a walk. The dog has no legs and is dragged along sidewalk on a little sled (mass of dog + sled = 13.0kg). The sidewalk exerts a frictional force of 14.0N.

  Find the speed of object

A mass of 1.60 kg stretches a vertical spring 0.335 m. If the spring is stretched an additional 0.164 m and released, how long does it take to reach the (new) equilibrium position again.

  Compare these to the escape speed from the earth

At what temperature would the rms speeds be equal to the escape speed from planet earth.

  Find the efficiency of the engine

Suppose a heat engine takes in 420 J of energy from a hot reservoir and performs 30 J of work in each cycle.

  Could she successfully sue for reinstatement or pay

She moves her family to New York and begins work. Three months later, she is fired for no stated cause. Could she successfully sue for reinstatement or pay?

  Find the magnitude of the acceleration of the electron

Find out the magnitude of the acceleration of the electron. How large is the pulling force it the wagon is moving with a constant speed.

  What angle does the rope make with the horizontal

What angle does the rope make with the horizontal.

  What is the beat frequency in hz

What is the beat frequency in Hz. A force of magnitude P pushes the block forward and downward as shown in the figure below. suppose the force is applied at an angle of 24.0° below the horizontal.

  What is the work done on the bow

An archer's bow can be treated as a spring with k = 2,900 N/m. what is the work done on the bow as the bowstring is pulled back into position

  Which is most possible to hurt-being stepped

A small grinding wheel has a moment of inertia of 4.0×10-5 kg m^2. What net torque must be applied to the wheel for its angular acceleration to be 160 rad s^2.

  What is the acceleration of the airbag

A car is traveling at 25 m/s when it runs off the road and hits a utility pole. What is the acceleration of the airbag

  Find the speed of the block at the bottom of the track

The speed of the block at the bottom of the track is vA = 13.1 m/s, and block experiences an average frictional force of 7.00 N while sliding up the track.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd