Determine the velocity of the bird

Assignment Help Mechanical Engineering
Reference no: EM13702407

A bird flying at a constant speed at an altitude 100 m is being tracked by a person located directly below the line of flight. If this angle is decreasing at 0.02 rad/s when the angle between the horizon line and the line of site is 45 degrees.

1. Determine the velocity of the bird (polar coordinates works best)

2. Determine r (double dot) and theta (double dot)

Reference no: EM13702407

Questions Cloud

Water cools at a rate : Water cools at a rate of 0.1 deg C per second as it flows in a pipe at 1 m / s. At any fixed location, the temperature is independent of time. If the pipe is 10 m long, what must the temperature be at the upstream end to keep the water temperature at..
The women dives first and the man dives first : A 90-kg man and 60-kg woman stand side by side at the same end of of 150-kg boat ready to dive, each with a 5-m/s velocity of the boat after they have both dived, if (a) the women dives first, (b) the man dives first.
Small angular oscillations of bar about the vertical axis : A uniform bar of length l and weight w is suspended symmetrically by two strings, set up the differential equation of motion for small angular oscillations of the bar about the vertical axis, and determine its period.
Heat transfer to the air in the heating section : Air at 14.7 psia, 50oF, and 60% relative humidity is first heated to 72  o F in a heating section and then humidified by introducing water vapor. The air leaves the humidifying section at 75oF and 55% relative humidity.
Determine the velocity of the bird : A bird flying at a constant speed at an altitude 100 m is being tracked by a person located directly below the line of flight. If this angle is decreasing at 0.02 rad/s when the angle between the horizon line and the line of site is 45 degrees.
Small angular oscillations of bar about the vertical axis : A uniform bar of length l and weight w is suspended symmetrically by two strings, set up the differential equation of motion for small angular oscillations of the bar about the vertical axis, and determine its period.
Calculate the force required to push liquid oil : Calculate the force required to push liquid oil, with the density of 890 kg/m^3, through a 1 mm diameter hole. Account for viscous forces and please show all work.
Suspended symmetrically by two strings : A uniform bar of length l and weight w is suspended symmetrically by two strings, set up the differential equation of motion for small angular oscillations of the bar about the vertical axis, and determine its period.
Total amount of heat required when the heat addition : A closed system contains 2 kg of Nitrogen at 27 C initially. The gas is heated to a final temperature of 277 C. Determine the total amount of heat required when the heat addition is done in.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the friction factor and the heat transfer

air at atmospheric pressure and with a mean velocity of 0.5 ms flows inside a thin walled square cross-section duct of

  Te position of a crate sliding down a ramp is given by x

the position of a crate sliding down a ramp is given by x 0.25t3 y1.5t2 z6-0.75t2.5 all in units of m where t is in

  Sum of losses coefficients valve and line 65 what force lbf

an safety relief valve is installed on a tank. the lines downstream and upstream of the valve are 8 in schedule 40

  All the components are ideal except the turbine which has

a steam power plant has a high pressure of 5 mpa and maintains 50 c in the condenser. the boiler exit temperature is

  For case c plot the acceleration velocity and altitude of

a parachutist of mass 70 kg jumps from a plane at an altitude of 32 km above the surface of the earth. unfortunately

  Identify the information used to make the decision

Given a simulator or actual device, identify if a control loop is in control or out of control and identify the information used to make the decision

  Find the maximum value of the principal stress and find the

a carbon steel ball with a diameter of 50 mm rests in a stainless steel hemispherical socket with a diameter of 60 mm.

  Calculate the angular separation between the first order

Calculate the angular separation between the first order minima on either side of the central maxima when the slit has a width of 6x10-4 cm & light illuminating it has a wavelength of 6000A0?

  Suppose we take 25 iid observations from normal

suppose we take 25 i.i.d observations from normal distribution with population standard deviation known to be 30.

  A heat pump is absorbing heat from the cold outdoors at

a heat pump is absorbing heat from the cold outdoors at 5oc and supplying heat to a house at 25oc at a rate of 18000

  At station 2 which is downstream of station 1 the pressure

assume air flows isentropically through a converging-diverging nozzle. at station 1 which is aft of the throat and has

  The exit conditions are 10 kpa with a quality of 9

steam flows steadily through an adiabatic turbine. the inlet conditions ar 10 mpa 450 degrees c 80 ms and inlet area of

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd