Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The cutoff frequencies of a series resonant circuit are 5400 Hz and 6000 Hz.
a. Find the bandwidth of the circuit.
b. If Qs is 9.5, find the resonant frequency of the circuit.
c. If the resistance of the circuit is 2-ohm, find the value of X and XC at resonance.
d. Find the value of Land C at resonance.
Each of the four members of a "jukebox jury" is provided with a pushbutton; the button is pressed if the record played is a "hit" and is not pressed if the record played is a "miss". Design a digital logic system that lights a lamp
If the output of the function generator for a sinusoidal waveform is 6 voltage divisions peak to peak and the voltmeter reads 2.12V, find the volts/div scale that is being used. If the frequency is 1 KHz and the peaks are 5 horizontal divisions ap..
AC Analysis Gain at Midband (with bypass capacitor in circuit) Connect the bypass capacitor using the switch.
use a third-order low pass filter with a -3dB frequency of 10 Hz to filter your signal. What sampling rate should you use to make sure any potentially aliasing frequencies are attenuated by at least -40 dB for a. A butterworth filter
Three single phase transformers rated at 100kVA, 13.2kV / 2.4kV are connected in wye -delta on a 3 phase, 18kV line. What is the maximum load that can be connected to the transformer bank
To prevent this, a device is placed across the solenoid (inductor) that can hold the voltage to a safe value, say 40V, during transients. If the activating current in the solenoid is 1 amp and its inductance is 100uH
Consider the current it takes to power a +5V 74xx245(Icc). What is the qualitative difference between the CMOS devices and the non-CMOS devices and the non-CMOS devices What is the explanation for the difference
A 3-phase 230 V, 9 kVA, 0.9 PF (lagging) load is supplied by 10 kVA, 1330/230 V, 60 Hz three-phase transformer connected in Y-?. The equivalent impedance of transformer referred to the low-voltage side is 0.12 + j0.25.
The voltage across the load must remain between 4.7 and 5.0 V for all values of load current. Come up with (draw) a voltage-divider network to supply the load. You may assume that resistors of any value desired are available.
a. Determine the voltage regulation, the load resistance, the armature resistance, and the developed torque at full load. b. The speed of the generator is decreased to 1200 rpm, and the load resistance is unchanged.
Let x1[n] = {-2,1,-3,-5,6,8} with arrow under -2 and x2[n]={1,2,3,4} with arrow under 1. a) determine circular convolution of 7 between x1[n] and x2[n] b) verify (a) calculations by computing the DFTs and IDFT.
The counter must stop at a value which is defined by using the 8 slide switches. Use two seven segment displays to implement the counter, there must be 2 individual counting bits each per seven segment display. The counter should run when a push b..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd