Determine the total load impedance per phase

Assignment Help Electrical Engineering
Reference no: EM13229801

A three-phase, 60Hz, wye-connected synchronous generator has balanced line-to-line voltages of 480V at its terminals. The generator is supplying power to two balanced and delta connected, three-phase loads. the first load is made up of three 15<-30 Ohm impedances, while the secound load is made up of three 18<50 Ohm impedances. Determine the following:

(a) Total (i.e.,equivalent) load impedance per phase (i.e.,line to neutral).

(b) The line current Ia at the generator terminal. use a phase voltage of Va=277.1281<0 V (since 480/(3^root) V =277.1281 V).

(c) The total complex power provideed by the generator.

Reference no: EM13229801

Questions Cloud

What is the economic justification for the rapid growth : What is the economic justification for the rapid growth of premium package services.
Determine the line current in balanced three-phase load : if a balanced, three-phase, 15MW total load is fed by a 138Kv power line at a 0.85 lagging power factor, determine the following. (a) The line current (b) The value of the capacitor in uf per phase, is a wye-connected capacitor bank is used to cor..
What challenges may arise if a u.s. project manager : Be specific and support your response with evidence from the readings or other materials. Please be sure to use APA format for citing your source(s).
Describe your approach to tracking a project : Describe your approach to tracking a project. What kinds of issues would you focus on if you were a project manager? Why?
Determine the total load impedance per phase : A three-phase, 60Hz, wye-connected synchronous generator has balanced line-to-line voltages of 480V at its terminals. The generator is supplying power to two balanced and delta connected, three-phase loads. the first load is made up
Determine the number of quantization levels : Work out the following problem: If the analog signal to be quantized is a sinusoidal waveform, that is, x(t) = 6 sin (6283t), and if the bipolar quantizer uses 8 bits, determine 1. Number of quantization levels; 2. Step size of the quantizer ; 3. ..
What is your assessment of the health of the project on day : On day 51, a project has an earned value of $600, an actual cost of $650, and a planned cost of $560. Compute the SV, CV, and CPI for the project. What is your assessment of the health of the project on day 51? Explain.
What is the net force that acts on the planes 80-kg pilot : An airplane has a mass of 3*10^4 kg and takes off under the influence of a constant net force of 35 000 N. What is the net force that acts on the plane's 80-kg pilot, assuming that he has the same acceleration as the plane
Find the maximum power delivered to the element : v(t)=20te^( -40t ) and i(t)=50te^( -40t ) for t>=0  both v and i are zeros for i

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the net profit for each digital thermometer sold

Consider the financial aspects of the digital thermometer project. The project cost is estimated at $10,000. The total manufacturing cost of the digital thermometer, as called for in the specifications, total $150(that is, $95 parts

  What is the corresponding pressure difference between points

Oil (density 0.91 g/cm^3) flows in a pipe (see fig.) and the flow rate is measured via a mercury manometer (density of Hg=13.546 g/cm^3). If the difference in height between the two legs of the manometer is 0.78 in.

  Explain resisitive load

Resisitive load, A 4:1 step down transformer uses a 60Vac source on the primary windings.

  Determine the speed of the wave travelling on the line

An overhead line with an inductance of 1.33 mH/km and capacitance of 8.34 nF/km is connected to an underground cable with an inductance of 0.266 mH/km and capacitance of 166 nF/km.

  Write down only the first three harmonics

Four frequencies are applied at the input of a non-linear amplifier. Write down all of the frequency components at the output of the non-linear device. Write down only the first three harmonics. Frequencies of 1205Khz, 1200Khz, 1195Khz

  Explain causes of difference between the emitted radiation

Compare this spectral distribution with that of the radiation received on the surface of the earth at AM1.5. Briefly explain the causes of the difference between the emitted radiation of the core of the sun and the received radiation at the earth'..

  What will be potential difference between plates seperation

An Air capacitor consisting of two closely spaced parallel plates has a capacitance of 1000 pF. The charge on each plate is 1 micro C. What is the potential difference between the plates. If the charge is kept constant.

  Determine whether the system is stable or not

A system has a characteristic equation: q(s) = s3 + 20s2 + 5s + 100 = 0 Determine whether the system is stable using the Routh-Hurwitz criterion. Determine the roots of the characteristic equation.

  Determine the heat input of the steam generator

pressure limits of 10 kPa and 8 MPa, with reheat occurring at 4 MPa. The temperature of steam at the inlets of both turbines is 500°C, and the enthalpy of steam is 3185 kJ/kg at the exit of the high-pressure turbine

  What should be the filter''s passband cut-off frequency

What should be the filter's passband cut-off frequency?(DSP Question).

  Which one will store most charge

For a circuit with resistor of 10 K ohm and a capacitor of 5 micro Farads, what is the time constant in second?

  How to close the temperature switch turns on

In a motor control system, one master stop pushbutton (Stop) is available for stopping the operation at any time. If the temperature switch (TSW) is closed, pressing the red pushbutton (RedPB) will turn on both motors M1 and M2.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd