Determine the total complex power consumed by two loads

Assignment Help Electrical Engineering
Reference no: EM13290294

A 3-phase power system consists of a wye-connected generatorconnected to the following loads, which are in parallel, through atransmission line. Load#1: Wye-connected load that consumes a total3-phase power of 3.6 kW at 0.8 power factor lag, when the generatorvoltage is set so that the voltage at the load is 480 V(line-to-line). Load #2: Delta-connected load that consumes 2kW + j1 kVar of power. The transmission line has an impedance,Zline = 1.2 angled at 60 degrees Ohm per phase.

a) Determine the total complex power consumed by these two loads.

b) Determine the line current magnitude and phase angle.

c) Determine the magnitude andphase angle of the line-to-line voltage at the generator.

Reference no: EM13290294

Questions Cloud

Find the magnitude of the momentum of the electron : The electron mass is 9×10?31 kg. What is the magnitude of the momentum of the electron
Explain what is the pca of the solution : We place some solid Ca3(PO4)2 [Ksp = 5.14x10-33] in water. After reaching equilibrium, what is the pCa (=-log[Ca2+]) of the solution
Human resource investigations : Human resource investigations include all but which of the following areas?
What can you tell her about validation therapy : What aspects would you consider in preparation for her discharge and what can you tell her about Validation therapy? Give an example (either a conversation or situation) of when she can use this technique with her husband.
Determine the total complex power consumed by two loads : A 3-phase power system consists of a wye-connected generatorconnected to the following loads, which are in parallel, through atransmission line. Load#1: Wye-connected load that consumes a total3-phase power of 3.6 kW at 0.8 power factor lag
Explain what is the ph of the buffer : We prepare a buffer by adding 0.4640 mol HNO3 to 0.5528 L of a solution containing 2.061 M trimethylamine [(CH3)3N, Kb = 6.500x10-5]. What is the pH of this buffer
Determine the electric field at the aircraft : An airplane is flying through a thundercloud at a height of 2300 m. (Flying at this height is very dangerous because of updrafts, turbulence, what is the electric field at the aircraft
Creative and innovative solutions for society''s problems : It is generally understood that social entrepreneurs are people with creative and innovative solutions for society's problems. They are possessed by their ideas and are committed to changing society for the better. Perform an Internet search to read ..
For how long will the flash light provide illumination : A 9-V flashlight battery has a rating of 1.8 kWh. If the bulb draws a current of 100mA when lit: determine the following: (a) For how long will the flash light provide illumination

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Describe two flaws with this initial experimental set-up

There is some interest from industry to be able to track the solidification or drying of the paint layer as it happens to ensure correct thickness and material properties. One way to do this would be to measure the changing values of the permittiv..

  Write an arduino code that reads temperature from thermistor

Write an arduino code that reads the temperature from a thermistor. This code must read a set temperature from the serial monitor and if the temperature from the thermistor is higher than the set temperature then a fan and led will turn on.

  Determine how many pins are needed for the ic package

A ROM chip of 1024 X8 bits has four select inputs and operates fron a 5 volt power supply. How many pins are needed for the IC package. Draw a block diagram and label all input and output terminals in the ROM.

  Calculate the velocity of the holes and electrons

(a) Calculate the velocity of the holes and electrons in this material. (b) What doping level is necessary to provide a current density of 2 mA/micrometer^2 under these conditions? Assume the hole current is negligible.

  Determine acceleration of the proton when it has a velocity

a proton moves through a region containing a uniform electric field given by E=50.0 v/m and a uniform magnetic field B=(0.200+.300+.400)T. Determine the acceleration of the proton when it has a velocity v=10.0m/s

  Find what is the average current drain from the battery

Suppose that we are designing a cardiac pacemaker circuit. The circuit is required to deliver pulses of 1-ms duration to the heart, which can be modeled as a 500 ohm resistance. The peak amplitude of the pulses is required to be 5 V.

  Determine what is the number in decimal

A number stored in IEEE single precision floating point format has S=0, E=0111 1101, and F=0.1000 0000 0000 0000 0000 000. What is this number in decimal

  What is probability of photo detectors in pair are defective

A machine produces photo detectors in pairs. Tests show that the first photo detector is acceptable with probability 3/5. When the first photo detector is acceptable, the second photo detector is acceptable with probability 4/5.

  Design a filter that satisfies the requirements of source

Design a filter that satisfies the following requirements: 1 input is a current source ranging from 4 mA to 20 mA with a source resistance of 10 ohms. 2 THe filter must output a voltage ranging from 2v to 10 v.

  Calculate the line-lo-line voltage at sending end of feeder

The transformer is supplying a load of 325 MVA, with 0.93 power factor lagging at a voltage of 24 kV (line-to-line) on its low-voltage side. It is supplied from a feeder whose impedance is 0.11 + j2.2 ohms connected

  Determine what size of copper wire is required

The generator voltage is 120 V and the lamp voltage should be 110 V or more. Calculate the current drawn by each lamp if its voltage is 110 V and its power is 100 W. Calculate the current in the two-wire line. Calculate the maximum resistance of t..

  Determine which frequency will be the aliased one

1) Determine the transfer of second-order highpass filter with a cutoff frequency of 900 Hz and passband gain of 1 using a butterworth type. 2) Design a filter for your transfer function using the sallen-Key topology.Find all the values of the circ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd