Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A point charge Q is located at (0,0,d) above an infiniteconducting plane that lies in the xy-plane and is maintained atground potential. Find a) the surface charge density as a function of x and y on the conducting plane and b) the total charge inducedon the conducting plane.
The variables are provided as high (1) and low (0) levels for digital control. An alarm should be initiated whenever any of the following occur: a. Speed is low; both weight and loading rate are high.
What is the minimum energy (in MeV) that is required to break a nucleus of 12C (of mass 11.99671 u) into three nuclei of 4He (of mass 4.00151 u each)
1.Explain aluminum migration in device contacts, and propose possible solutions for the aluminum spikes caused by the migration. 2.What are the two methods for the first step of impurity doping Why a second drive-in step is needed
A 250ft^2 shell and tube heat exchanger was purchased fo $13,500 in 1994 when the index value was 830. Estimate the cost of a 150 ft^2 shell and tube heat exchanger in 2010 when the index calue is 1,029 and the appropriate factor is 0.6.
The switch in the circuit has been in position a for a long time. At t=0 the switch is moved to position b. A.Calculate the initial voltage on the capacitor ifv = 200V , and i = 1.9mA . B. Calculate the final voltage on the capacitor. C. Calculate t..
A "shift and add" multiplier works as follows: given two n bit numbers X and Y , look at the LSB of X: if it is one, then add Y to the running sum. If it is zero, then don't do anything (since multiplying by 0 is 0!). Next, shift X to the right by..
If this op amp is used in a non-inverting amplifier having a closed loop dc gain of 100, sketch the bode plot of the magnitude of the closed loop gain to scale. Repeat for a closed-loop dc gain of 10.
Two skaters are moving towards each other on an ice rink. One skater (m1=45 kg) has a speed of 8.3 m/s towards the right. The other skater (m2=73 kg) has a speed of 4.8 m/s to the left. The skaters collide and grab on to each other.
Assume the factory described in the previous problem is fed from a line having an impedance of 0.02 + j0.16-ohm. The voltage at the factory is maintained at 480 V(rms). Find the average power loss in the line before and after the load is added.
A 2N3904 has a power dissipation of 625mW without a heat sink. If the ambient temperature is 65 degree C, what happens to the power rating
Need to use multisim and proteus and have build the circuit diagram on multisim and proteus, also have the program written, all u need to do its simulate it and take the necessary results.
The bellows, diaphragm, and Bourdon tube pressure sensors all exhibit second order time response. This means that a sudden change in pressure will cause an oscillation in the displacement and, therefore in the sensor output.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd