Determine the thickness of the bar

Assignment Help Mechanical Engineering

Reference no: EM13704604

A flat bar as shown in the figure below is subjected to an axial load F equal to 500 kn. Assuming that the stress in the bar is limited to 200 n/mm^2 determine the thickness of the bar. All dimensions are in mm

Reference no: EM13704604

Questions Cloud

Predict the performance of turbine : A Turbine develops 40,000KW power by running at a speed of 150 rpm at a head of 25 m. The discharge required is 150m^3/s. If the head of the turbine is reduced to 20 m. Predict the performance of turbine?

Adiabatic flame temperature for constant pressure : Determine the adiabatic flame temperature for constant pressure combustion of a stoichiometric propane air mixture assuming reactants at 298 k . No dissociation of the products and constant specific heats evaluated at 298 k.

Consider the equilibrium reaction in a closed vessel : Assume the vessel contains 1 mole of O2when there is no dissociation. Calculate mole fraction of O2 and O for the following conditions. Comment on how pressure and temperature impacts equilibrium composition and if the changes are consistent with Pri..

Fluid flow through a non-circular cross-section pipe : The pipe flow experiment deals with fluid flow through a non-circular cross-section “pipe”. Please explain, using supporting equations, how you would calculate the pressure loss during fluid flow between two points along the pipe.

Determine the thickness of the bar : A flat bar as shown in the figure below is subjected to an axial load F equal to 500 kn. Assuming that the stress in the bar is limited to 200 n/mm^2 determine the thickness of the bar. All dimensions are in mm

Dimensional rotation have real eigenvalues and eigenvectors : When does a 2x2 orthogonal matrix Q with det(Q) = 1 describing a 2 dimensional rotation have real eigenvalues and eigenvectors?

A rubber-tired scraper with an efficiency : A rubber-tired scraper with an efficiency of 50 min/hr has a heaped capacity of 20 cu yd. If it is to move material with a swell factor of 25%, what amount of in-bank material can it move in 1 hr, assuming it has a total cycle time of 5 min?

Power input to the compressor and the rate of heat transfer : Determine the power input (hp) to the compressor and the rate of heat transfer (Btu/hr) removed from the nitrogen in the heat exchanger.

Determine the temperature and phase of water : Determine the temperature and phase of water from the following information. If the phas is a vapor-liquid mixture, report the fraction of vapor and liquid.

User Account

All Pages