Determine the stress-strain-youngs modulus

Assignment Help Mechanical Engineering

Reference no: EM13706641

A steel rod of radius 0.01 m and length 2. M is pulled on with a tensile force of 200,000 N, and the bar stretches to a length of 2.08 m. The radius of the bar is reduced to 0.0099 m.

Determine the stress, strain, Young's modulus (E), and Poisson's ratio (v) from this test. Use the Young's modulus and Poisson's ratio to determine the Bulk Modulus and Shear Modulus.

Reference no: EM13706641

Questions Cloud

Determine the new volume of the gas : 0.112m^3 of gas has a pressure of 138kN/m^2. It is compressed to 690kN/m^2 according to the law PV^1.4 = C. Determine the new volume of the gas.

In a non-flow process there is a heat loss : In a non-flow process there is a heat loss of 1055kJ and an internal energy increase of 210kJ. How much work is done and is the process an expansion or compression?

Air passes through a gas turbine system : Air passes through a gas turbine system at a rate of 4.5kg/s. It enters with a velocity of 150m/s and a specific enthalpy of 3000kJ/kg. At exit, the velocity is 120m/s and the specific enthalpy is 2300kJ/kg. The air has a heat loss to the surrounding..

Find the specific gravity of the material : A cube of material is 4 in. on a side and floats at the interface between kerosene and water, as shown in the figure. Find the specific gravity of the material.

Determine the stress-strain-youngs modulus : A steel rod of radius 0.01 m and length 2. M is pulled on with a tensile force of 200,000 N, and the bar stretches to a length of 2.08 m. The radius of the bar is reduced to 0.0099 m. Determine the stress, strain, Young's modulus (E), and Poisson's r..

Manufacturer claims the average velocity of air leaving fan : A fan with a diameter of 12 inches operates at a voltage of 120V with a current draw of 0.5 amps. The manufacturer claims the average velocity of air leaving the fan is 33.1 ft./s under standard conditions. Standard air has a density of 0.075 lb mass..

Compressor with an internal energy : Saturated steam at 230 degrees F, 20.78 psia and 19.386 ft cubed per pound of mass enters a compressor with an internal energy of 108.26 Btu/lb of mass and is compressed to 80 psia. the mass flow rate is 50 lb mass per hour. Heat loss from the compre..

Initial and final temperature of liquid due to heat transfer : A 50 kg hot iron block is dropped into a relatively cold lake at temperature T. During thermal equilibrium the lake receives Q amount of heat from the iron block. Show that the entropy change of the lake is Q/T starting with an expression for the spe..

Work required using the saturated liquid approximation : Saturated liquid water at 25 degrees C is pumped to a pressure of 5 MPa in an isothermal process. The specific work required by the pump to pressurize the water to 5 MPa can be found as the change in enthalpy of the water from the inlet pressure to t..

User Account

All Pages