Determine the static head efficiency required of the

Assignment Help Mechanical Engineering
Reference no: EM13635416

In an automotive gas turbine the centrifugal compressor is driven at 40,000 rpm by an axial turbine. The compressor impeller is 180 mm dia. With radial vanes and there is no inlet swirll the slip factor is 0.9 and the isentropic efficiency is 80% If there is a 5% loss in total pressure in the intervening combustion system in where the air is heated to 950C, determine the static head efficiency required of the turbine if the total pressure of its exhaust is not to be less than 1.6 bar and the exhaust velcotiy is 300 m/s. Ambient condition are 300K and 1 bar, and for air take Cp=1.01 kj/Kg K and sp. Heat ratio = 1.4, formthe gases take Cp= 1.15 kJ/kgK and sp. Heat ratio = 1.33.

Reference no: EM13635416

Questions Cloud

Asample volume of 05ml was pipetted into a beaker treated : a sample volume of 0.5ml was pipetted into a beaker treated withreagents to produce an indigo color transferred to a
The system is released from rest if there is no sipping : a board lies on top of 2 uniform cylinders that lie on a fixed plane inclined at an angle theta. the board has mass m
Develop a relation between dpdx u1 and u2 that ensures that : an incompressible newtonian fluid flows steadily between two parallel plates. the bottom plate moves to the left at a
A child and sled with a combined mass of 486 kg slide down : a child and sled with a combined mass of 48.6 kg slide down a frictionless hill that is 8.94 m high. if the sled starts
Determine the static head efficiency required of the : in an automotive gas turbine the centrifugal compressor is driven at 40000 rpm by an axial turbine. the compressor
If a sample of gold with a mass of 2857 g is pressed into a : gold which has a density of 19.32 gcm3 is the most ductile metal and can be pressed into a thin leaf or drawn out into
Aproximately 80 of the mass of a human body consists of : 1. approximately 80 of the mass of a human body consists of aqueoussolutions spinal fluid blood etc. these solutions
Determine the rotor diameter and the nozzle angle if the : an inward radial flow turbine is to develop 400 hp when supplied with air at 800c and 3 bar abs the exhaust total
A sample of n2 gas occupies 240 l at 20c if the gas is in : 1. a sample of n2 gas occupies 2.40 l at 20?c. if the gas is in acontainer that can contract or expand at constant

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The mass of the piston is such that a cylinder pressure of

10 kg of water in a piston-cylinder arrangement exists as saturated liquidvapor at 100 kpa with a quality of 50. it is

  Determine for the turbine a the mass flow rate in kgs b the

water vapor at 10 mpa 600 degrees c enters a turbine operating at steady state with a volumetric flow rate of 0.36 m3

  Find the lift and drag per meter span acting on the airfoil

Consider two-dimensional flow over the double-wedge airfoil shown. Find the lift and drag per meter span acting on the airfoil and sketch the flow pattern. Find the pressure acting on all surfaces.

  A closed system contains 2-kg of air undergoes an

a closed system contains 2-kg of air undergoes an isothermal process from 600 kpa and 200oc to 80 kpa. determine the

  Calculate the percent energy distribution in a steam

calculate the percent energy distribution in a steam generator that goes into steam losses to flue gases refuse and

  Determine the energy change if the system mass

For the process where q= 62.5 kj/kg and wkcs= 60 kj/kg determine the energy change if the system mass is 2 kg.

  A steam turbine operating at steady state has water

a steam turbine operating at steady state has water entering at 3mpa 500 degrees c and velocity of 10ms the water exits

  In such an experiment for which steady state operation is

the thermal characteristics of a small dormitory refriderator are determined by performing two separate experemints

  Two blocks of steel cp011 btulbm ordmf one at 800ordmf and

two blocks of steel cp0.11 btulbm ordmf one at 800ordmf and the other at 300ordmf are brought into contact in an

  Why is this problem simpler than for the turbulent boundary

consider heat transfer to a turbulent boundary layer with no pressure gradient or transpiration but with a vanishingly

  Starting with the energy equation q - w u2 -u1 show that

during a constant pressure process 10 kg of refrigerant 134a at 4degrees c and 10 bars expand to a volume of 0.1 m3.a

  What is the initial temperature of the water

A piston-cylinder device contains 0.005 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 600 kPa. Heat is transferred at constant pressure until the temperature reaches 200°C.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd