Determine the speed of the wave travelling on the line

Assignment Help Electrical Engineering
Reference no: EM13218364

An overhead line with an inductance of 1.33 mH/km and capacitance of 8.34 nF/km is connected to an underground cable with an inductance of 0.266 mH/km and capacitance of 166 nF/km.

a. Determine the speed of the wave travelling on the line and cable.
b. Determine the distance can the wave travel on the line and cable at 2 μs.
c. A travelling wave is approaching to the connection point with a voltage of
Ui = "411" kV. At the connection point, determine the voltages and currents after the first reflection and refraction.
For the voltage at the connection point not to exceed 20 % of the incident wave (20% Ui); a resistor will be connected to the joint. Determine the resistance of the resistor connected in parallel to the connection point.

 

Reference no: EM13218364

Questions Cloud

How to classify each project as either simple or nonsimple : Consider the following sets of investment projects: n A B C D E 0 -$250 -$200 -$70 -$300 -$90 1 $60 $90 $20 $220 -$100 2 $970 $90 $10 $40 -$50 3 $60 $5 $40 $0 4 $60 -$180 -$20 $150 5 $60 $40 $150 6 $50 $30 $100 7 $40 $100 8 $30 9 $20 10 $10
Explain what is the molarity of compound b : A solution is prepared by dissolving 1.00 g of Compound B in enough water to create 250.0mL of solution. What is the molarity of Compound B in this solution?
Calculate the value of vl developed across : Calculate the value of vL developed across a 300 H coil when the instantaneous rate of change in component current equals 500 mA/s.
What is value that should be used as p for owned vehicle : A truck was purchased 3 years ago for $45,000 and can be sold today for $24,000. The operating costs are $9,000 per year, and it is expected to last 4 more years with a $5,000 salvage value. A new truck, which will perform that same service.
Determine the speed of the wave travelling on the line : An overhead line with an inductance of 1.33 mH/km and capacitance of 8.34 nF/km is connected to an underground cable with an inductance of 0.266 mH/km and capacitance of 166 nF/km.
Describe stock solutions of glucose : Given stock solutions of glucose (1M), aparagine (100 mM) and NaH2PO4 (50 mM), how much of each solution do you need to prepare 500 mL of a reagent that contains 0.05 M glucose
Explain how many megajoules of energy in the form of heat : how many megajoules of energy in the form of heat can be produced per year (365 days) by the heater
How much hydrogen would be needed : How much hydrogen would be needed to give the car a range of 300 miles if the source of electricity is an on-board fuel cell with an efficiency that is 50% of the ideal?
Calculate the average torque and maximum torque : When the two windings are connected to a a.c supply of 50hz, the field current is 0.1A, the armature current is 100A and the phase difference between them is 60 degree. calculate the average torque and maximum torque.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Use phasors to obtain a complex signal

In class we saw an example of 'Beat note'. In this problem we consider a more general case. Let fc > 0, fd > 0 and define a signal x as.

  Explain signals obtained separately in the radio receiver

How are the left (L) and right (R) signals obtained separately in the radio receiver to drive the dual channel audio amplifier and speakers?

  Ac analysis gain at midband with bypass capacitor

AC Analysis Gain at Midband (with bypass capacitor in circuit) Connect the bypass capacitor using the switch.

  Explain problem on complex power

Problem on complex power, An electric load operates at 240 volts. The load absorbs an average power of 8Kw at a lagging power factor of 0.8.

  Design an rc-low pass filter

Design an RC-Low Pass Filter with cutoff frequency at fc=0.5GHz and plot its frequency response and design a parallel resonance circuit with resonance frequency of 30kHz and bandwidth of 20kHz and plot its frequency response.

  Explain one signaling element is used to represent

Bandwidth, In a given communications system, one signaling element is used to represent 64 bits. The required data rate is 1.789 Mbps.

  Explain what is the conductance of two parallel conductors

What is the relation between the conductance and the capacitance of two parallel conductors immersed in a lossy dielectric medium that has permittivity and conductivity?

  Create a flowchart and pseudo-code for generating

Create a flowchart and pseudo-code for generating a report that prints all of the movies, with all movies made by the same director on one page, as well as the number of movies by each director.

  Calculate the first two energy levels

A one-dimensional infinite potential well with a width of 12 Ao contains an electron. (a) Calculate the first two energy levels that the electron may occupy. (b) If an electron drops from the second energy level to the first, what is the wavelengt..

  Transactive memory system

What are some of the possible biases and points of error that may arise in team communication systems and what are the advantages and disadvantages of a transactive memory system (TMS) in a team

  Explain what is the primary purpose of a resistor in series

What is the primary purpose of a resistor in series with a LED being driven by a flip-flop?

  Explain finding rms current through capacitor and inductor

Finding rms current through Capacitor and Inductor, A circuit consists of a sine wave signal generator and a reactive component (L or C). The output of the generator is a sine wave with a peak amplitude of 8.8 volts at a frequency of 10.0 kHz.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd