Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Consider the circuit in given figure. Use standard transistors.
Using a computer simulation, determine the small-signal differential-mode voltage gain and common-mode voltage gain for (a) RL = 10 MΩ and (b) RL = 200 kΩ.
What is the difference between constant voltage biasing, constant voltage biasing with a source resistance, and constant current source biasing, in terms of advantages and disadvantages over the other techniques.
An analog signal consists of three sinusoids with frequencies3.1 KHz, 4.82 KHz, and 5.64 KHz. The signal is sampled at asampling rate of 32 KHz producing the Discrete signal x(n). Determine the normalized frequencies in x(n).
The open-circuit and short-circuit impedances measured at the input terminals of a lossless transmission line of length 1.5(m), which is less than a quarter wavelength, are -j54.6 (μ) and j103 (μ), respectively. Find Zo of the line.
Power Systems Theory Definitions and Formulas, Define, (a) The fault level of a system or unit in a system, (b) base MVA
Draw a state diagram for an FSM that has an input X and an output Y. Whenever X changes from 0 to 1, Y should become 1 for two clock cycles and then return to 0 - even if X is still 1
Assume we need to design a cellular system that covers an areaof Radius R=20 miles.For practical reasons (cost of BS , handoffcapability,etc.) ,each cell should cover at least an area of radiusr=1 mile.FDD is used and that each simplex channel re..
a. Convert all the per unit values to a common kVA of 100 and transmission side voltage base of 2500V b. To maintain one per unit voltage at rated load, find the per unit generator voltage needed.
Second order unity gain Tschebyscheff low pass filter. The task is to design a second order unity gain. Tschebyscheff low pass filter with a corner frequency of fc = 12.5kHz and a 3dB passband ripple. Determine C1, C2, R1, and R2.
This relationship allows the impedance tuning techniques of Chapter 5 to be used to design the input and output matching networks for an amplifier.
1.for the unity feedback control system with an open-loop transfer function shown below ltbrgt
Determine the current I and the voltages Va, Vb, and Vab for the network of given figure.
Calculate the inductance of a coil that induces 850V when the current through it changes at a rate of 30mA - Calculate the energy store in a 20mH inductor.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd