Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Palladium (II) forms an intensely colored complex at pH 3.5 with arsenazo III at 660 nm.33 A meteorite was pulverized in a ball mill, and the resulting powder was digested with various strong mineral acids. The resulting solution was evaporated to dryness, dissolved in dilute hydrochloric acid, and separated from interferents by ion-exchange chromatography. The resulting solution containing and unknown amount of Pd(II) was then diluted to 50.00 mL with pH 3.5 buffer. Ten-milliliter aliquots of this analyte solution were then transferred to six 50.00 mL volumetric flasks. A standard solution was then prepared that was 1.00×10-5 M in Pd(II). Volumes of the standard solution shown in the table were then pipetted into the volumetric flasks along with 10.00 mL of 0.01 M arsenazo III. Each solution was then diluted to 50.00 mL, and the absorbance of each solution was measured at 660 nm in 1.00-cm cells.
(a) Enter the data into a spreadsheet. and construct a standard-additions plot of the data.
(b) Determine the slope and intercept of the line.
(c) Determine the standard deviation of the slope and of the intercept.
(d) Calculate the concentration of Pd(II) in the analyte solution.
(e) Find the standard deviation of the measured concentration.
a contact feedwater heater operates on the principle of mixing steam and water. steam enters the heater at 100 psia and
a regenerative steam cycle operates between the limits of 80 bar 540oc and 0.05 bar. if only one extraction from the
a packed bed is composed of crushed rock with a density of 175 lbmft3nbspof such anbspsize and shape that the average
determine the horsepower input for a motor necessary to lift a 200 kg box at a constant rate of 2 ms. the overall
a shaft consisting of a steel tube of 50 mm outer diameter needs to transmit 100 kw of power while rotating at a
Calculate the work during the process. Explain whether the work is done on the system or by the system and determine what phase or phases are initially present in tanks A and B.
two slender rods of negligible weight are pin-connected at a and attached to the 18-lb block b and the 80-lb block c as
the springs of an automobile trailer are compressed 10.6 cm under its weight. find the critical speed when the trailer
consider a regenerative cycle utilizing steam as the working fluid. steam enters the turbine at 3.5 mpa 400oc and
air enters a compressor at 300 k and 100 kpa at a volumetric flow rate of 4 m3s. the air is compressed such that the
approximately how many pounds of downward pressure is placed on a piston in an internal combustion engine at the moment of ignition? I know this will vary some depending on the type fuel, the size of the combustion chamber and ect.
Water cools at a rate of 0.1 deg C per second as it flows in a pipe at 1 m / s. At any fixed location, the temperature is independent of time. If the pipe is 10 m long, what must the temperature be at the upstream end to keep the water temperature at..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd