Determine the resistance of the photoconductive cell

Assignment Help Electrical Engineering
Reference no: EM131203219

Problem 1:

a. Using the characteristics of given Figure, determine the resistance of the photoconductive cell at 10 and 100 foot-candles of illuminaton. As in Problem 2, note that it is a log scale.

b. Does the cell have a positive or a negative illumination coefficient?

c. Is the coefficient a fixed value for the range 0.1 to 1000 foot-candles? Why?

d. What is the approximate rate of change of R with illumination at 10 foot-candles?

2258_Photoconductive cell.jpg

Problem 2

a. Find the resistance of the thermistor having the characteristics of given Figure at -50°C, 50°C, and 200°C. Note that it is a log scale. If necessary, consult a reference with an expanded log scale.

b. Does the thermistor have a positive or a negative temperature coefficient?

c. Is the coefficient a fixed value for the range -100°C to 400°C? Why?

d. What is the approximate rate of change of with temperature at 100°C?

 

1873_Thermistor.jpg

Reference no: EM131203219

Questions Cloud

What is the resistance of a copper bus bar : What is the resistance of a copper bus-bar, as used in the power distribution panel of a high-rise office building, with the dimensions indicated in given figure?
Personal responses to two discusion posts : The process of assumption depends on the organization resources. Different organizations, use different methods. It takes commitment and responsibility to coordinate the research effort. First, a clear vision and purpose of the research must be e..
Create a new product that would appeal to your market : Develop at least one question for each characteristic of the target market (demographic, geographic, psychographic, and behavioral) that will be important for you as you determine the marketing strategy for this new product.
Describe the black hole illusion during landing : SCA1117 Assessment - Essay: Black Hole Illusion. Describe the Black Hole Illusion during landing and its impact on aviation safety. Discuss different variables that may affect the onset and strength of the Black Hole Illusion during landing
Determine the resistance of the photoconductive cell : Using the characteristics of given Figure, determine the resistance of the photoconductive cell at 10 and 100 foot-candles of illuminaton.
Why said that in-n-out burger has type of cult following : Why do you think In-N-Out Burger has an estimated 20% profit margin while McDonald's reports a 6% profit margin? How would you describe the competition between In-N-Out Burger and Five Guys?
Analyze how you would respond to joint commission concerns : Prepare a 2-slide each Microsoft PowerPoint presentation with detailed speaker notes for the executive committee of the hospital that includes the following information: Analyze how you would respond to Joint Commission concerns
Find all the equilibrium points of the system : Find all the equilibrium points of the system. Use capital letters to denote equilibrium conditions, for instance E , I and Xc will be a constant voltage at equilibrium, etc. Note that this system does not have a unique equilibrium.
How do the above marketing efforts influence people : Gladwell argues that marketing research techniques like focus groups are not effectivebecause we usually react to products quickly and without much conscious thought. So, it's better to solicit consumers' first impressions rather than getting them..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find what is the maximum number of possible transitions

If an FSM has N states, what is the maximum number of possible transitions that could exist in the FSM. Assume that no pair of states has more than one transition in the same direction and that no state has a transition point back to itself.

  What is the base-emitter voltage of the latter transistor

In a particular technology, a small BJT operating at vBE = 28VT conducts a collector current of 100 µA. What is the corresponding saturation current. For a transistor in the same technology but with an emitter junction that is 32 times larger.

  Design a system using the photoconductive cell

Design a system using the photoconductive cell

  Determine the magnitudes of the voltage across the capacitor

A 20 V source with a Thevenin Resistance of 3 Ohms is set to the resonant frequency and connected to the RLC circuit. Draw the circuit diagram and determine the magnitudes of the voltage across the capacitor and the total voltage across the RLC ci..

  Draw hardware logic diagram using and-or logic

Design a counter to count even numbers between 0 and 15. Therefore states will be 0 -> 2 -> 4 -> 6 -> 8 -> 10 -> 12 -> 14 -> 0. If any unused state is encountered bewteen 0 and 7, then the counter should go back to initial state 0.

  What is the torque on the loop from the magnetic field

A coil of wire contains 50 square turns, each one 5 cm long and 3 cm wide, and has a current of 30 A running through it. it is placed inside a magnetic field of 0.55 T at a 60 degree angle. what is the torque on the loop from the magnetic field

  Determine which would be no financial benefit to the owner

According to the tariff the owner agreedwith the utility company, the income generated is $0.16 per kWh atany time of the day. This figure is expected to rise annualy by20%. Ignore interst rates, any fluctuations in dollar etc.

  Give signal multiplied by a periodic rectangular pulse train

A aperiodic signal x(t) = 2sinc(2t) is multiplied by a periodic rectangular pulse train s(t) with fundamental frequency F0 = 4 Hz and the fundamental rectangular pulse given by p(t) = 1, -1/80

  Find relation for the potential across the depletion region

Consider a linearly graded Si p-n junction. Find a relation for the potential across the depletion region. Hint: Start from equation 29 in chapter 3 of the text book. Integrate the electric field to find the potential.

  What is the probability that all bits are 0s

In a test of a printed circuit board using a random test pattern, an array of 10 bits is equally likely to be 0 or 1. Assume the bits are independent. (a) What is the probability that all bits are 1s (b) What is the probability that all bits are 0s

  Design a one-op-amp high-pass filter with a gain

Design a one-op-amp high-pass filter with a gain of 20 and a cornerfrequency of 0.05Hz. Calculate its response to a step input of1mV.

  Construct the transition table for the sequential circuit

Given the following next state and output equations for a synchronous sequential circuit:a. Construct the transition table (state table) for the circuit showing present states, next states and outputs. b. Draw a state graph for the circuit.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd