Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 2722-kg weight is being pushed up an inclined surface at constant speed by a cylinder. The coefficient of friction between the weight and inclined surface equals 0.15. for a pressure of 6.9 MPa, determine the required cylinder diameter.
A ball of radius 1 meter centered at the origin has uniformly distributed over its volume a positive charge Q. a. In moving a positive test charge from the point (x, y, z)= (2, 2, 2) to the point (4, 4, 4), do you have to do work on the test charge..
A rod on the surface of Jupiter's moon Callisto has a volume of 0.3 cubic meters. Determine the weigh of the rod in units of pounds-force. The specific gravity is 4.7 gravitational acceleration on Callisto is 1.25 meters per second squared.
The treasure map in the figure gives the following directions to the buried treasure: "Start at the old oak tree, walk due north for 530 paces, then due east for 130 paces. Dig." But when you arrive, you find an angry dragon just north of the tree..
Design the basic interface circuit (using an op amp) for a temperature sensor that covers a range of 0 degrees to 70 degrees C if the output of the sensor is 2 mV/1C and the ADC voltage range is 0 to 4 V.
A temperature transducer has the relationship R=200 + 10T where R is in ohms and T is in Celsius. The problem specifications are: Range is 30=T=50°C Resolution is 0.01°C Frequencies of interest are 0 to 100Hz Transducer dissipation constant is 20 mW..
Charges +Q and +3Q are separted by a distance 2m. A third charge is located such that the electrostatic system is in equilibrium. Find the location and kthe value of the third charge in terms of Q.
It requires the frequency resolution to be less than 0.5 Hz. Determine the number of data points used by the FFT algorithm and actual frequency resolution in Hz, assuming that the data samples are available for selecting the number of data points.
the Mars Rover Spirit got stuck in the Martian sand. The wheels kept slipping. Attempts to free it were futile. Discuss the type of actuator in this case. Can you suggest any improvements in the actuator that would have prevented this unfortunate ..
From the definition of polarization (p) Perrin equation, and anisstropy (r) introduced by Jablonski, derive the interchangeable relation between p and r.
An amplifier with an input impedance of 50 K-ohm, an open circuit voltage gain of 150 V/V, and an output impedance of 100 ? is connected between a 5 K-ohm signal source and a 1 K-ohm load.
In a typical AC circuit, the supply voltage is 10 VPK and frequency is 60 Hz. If the current through the system is 2 APK with a phase angle of 60o, then the power dissipated by the source is
A GAL is different from a PAL because A GAL has more inputs and outputs; A GAL is implemented with a different technology; A GAL can replace several different PAL's; A GAL can be reprogrammed and a PAL cannot
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd