Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A fillet weld is used to join 2 medium carbon steel plates each having a thickness of 5.0 mm. The plates are joined at a 90° angle using an inside fillet corner joint. The velocity of the welding head is 6 mm/sec. Assume the cross section of the weld bead approximates a right isosceles triangle with a leg length of 4.5 mm, the heat transfer factor is 0.80, and the melting factor is 0.58. Determine the rate of heat generation required at the welding source to accomplish the weld.
In our stress calculation example, we had an array of rod diameters and wanted to calculate the normal stress in each rod when it is loaded by an axial load P of 1000 lbs. EDU stresscalc ?
consider a solid rod with diameter d and length l subjected to torsion t and moment m at both ends shown in fig. 1.
Express the scalar product of two vectors in terms of their covariant and contravariant components.
A suspension of calcium carbonate particles in water flows through a pipe. Your assignment is to determine both the flow rate and the composition of this slurry. You proceed to collect the stream in a graduated cylinder for 1.00 min; you then weig..
a 10 m3 oxygen tank is at 15 degree c and 800 kpa. the valve is opened and some oxygen is allowed to escape until the
A four cylinder, 3.6 liter CI engine operates with a compression ratio of 18 and an air fuel ratio of 17. The engine operates on a dual cycle. The maximum pressure is limited to 12 MPa and the maximum temperature is limited to 3600 K. Assume that ..
in a compton experiment an electron attains a kinetic energy of 0.1 mev when a 0.5mev x-ray strikes it. determine the
If the outlet temperature of the oil is 60°C, determine the total heat transfer and the outlet temperature of the water. Determine the length required for the heat exchanger.
What is the cross sensitivity of a sensor? Indicate how the anisotropy of piezoelectric crystals (i.e., charge sensitivity quite large along one particular crystal axis) is useful in reducing cross-sensitivity problems in a piezoelectric sensor.
If the ventilation requirement of a 2.7-m-high, 200-m2 residence is tobe met entirely by a fan, determine the flow capacity in L/min of thefan that needs to be installed. Also determine the diameter of the duct if the air velocity is not to exceed ..
Using the simple stretch-based hyperelastic equations discussed in Section 5.6.5, show that the principal stresses for a simple shear test are
Water in a vertical piston cylinder is heated at constant pressure of 10 bar. It is initially at 179.9 0C and has a specific volume of 0.1 m3/kg and is heated to a final specific volume of 0.248 m3/kg. Changes in kinetic and potential energies are ze..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd