Determine the power input to the fan the exit volume flow

Assignment Help Mechanical Engineering
Reference no: EM13622149

A straight duct with a radius of 40 cm contains a fan that is operating at steady state. The fan draws air from the left at 20 m3/min, 95 kPa, 20 C and it exits the duct at 115 kPa, 40 C. Heat transfer occurs from the duct to the surroundings at a rate of 2 kW. Determine the power input to the fan, the exit volume flow rate, and the inlet and exit velocities. Assume that air behaves as an ideal gas with constant specific heats Cp = 1.004 kJ/(kgK) and Cv = 0.717 kJ/(kgK). Neglect changes in potential and kinetic energy.

Reference no: EM13622149

Questions Cloud

In a sample of 270 households in a certian citym 210 had : in a sample of 270 households in a certian citym 210 had high speed internet access. can you conclude that more than 70
A 105-kg uniform board is wedged into a corner and held by : a 10.5-kg uniform board is wedged into a corner and held by a string at a 50 degree angle. calculate the tension in the
In 2008 the per capita consumption in country a was : what is the probability that someone in country a consumed more than 12 pounds of coffee in 20008?in 2008 the per
In 2008 the per capita consumption in country a was : what is the probability that someone in country a consumed more than 12 pounds of coffee in 20008?in 2008 the per
Determine the power input to the fan the exit volume flow : a straight duct with a radius of 40 cm contains a fan that is operating at steady state. the fan draws air from the
Suppose that intrests rates offered for refinancing are : suppose that intrests rates offered for refinancing are normally distributed with a mean of 3.0 and standard deviation
Suppose the participants for jury duty are picked from a : suppose the participants for jury duty are picked from a large pool of county residents with equal numbers of men and
Estimate the extent of the laminar boundary layer flow will : an airplane flies at a speed of 539 mph at an altitude of 10000 ft. if the boundary layers on the wing surfaces behave
The marketing research team of an investment corporation is : the marketing research team of an investment corporation is trying to determine its target market for the promotion of

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A satellite is in earth orbit with an altitude at perigee

a satellite is in earth orbit with an altitude at perigee of 555.0 km and an altitude at apogee of 1200.0 km. a. what

  Find the mass of gasoline fuel injected into each cylinder

Please find the mass of gasoline fuel injected into each cylinder in each working cycle.

  Test the hypothesis that both machines fill to the same net

two machines are used for filling glass bottles with a soft-drink beverage. the filling process have known standard

  Using the mechanical energy balance estimate the time

using the mechanical energy balance estimate the time required for the water level to drop from an upper piece of tape

  Combustion heats it to 1500 k in a constant-volume process

air in a piston-cylinder device has 400 degrees f 1000 kpa with a volume of 3.5 ft3. combustion heats it to 1500 k in a

  For a vertical cylinder with an electric heater 2500watt at

for a vertical cylinder with an electric heater 2500watt at the basean inletlower part of cylinder with cold water at

  What water mass flow rate is required report your answer

now consider the cooling process. it takes place in a heat exchanger hx. warm air. at 75 f is flows into one side of

  Read the titled books drilling fluid engineering manual

read the titled books drilling fluid engineering manual. textbook prepared by m-i drilling fluids co.1998 halliburton

  Question 1 entropya in a coal fired thermal power station

question 1 entropya in a coal fired thermal power station indicate where the exergy contained in the coal is destroyed.

  Determine the fatigue strength at 5 x 105 cycles what is

the fatigue data for a brass alloy are given as followsstress amplitude mpa -----------------cycles to failure310

  Tarzan king of the jungle mass 662 kg grabs a vine of

tarzan king of the jungle mass 66.2 kg grabs a vine of length 14.6 m hanging from a tree branch. the angle of the vine

  He drive sprocket has 19 teeth and the sprocket on the

the shaft of a gearbox is coupled through a no. 60 chain drive rotating a concrete mixer at 180 rpm clockwise. the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd