Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The field current of a 200kW, 230V shunt generator is 8A. When running full load at rated voltage. If the combined brush contact and armature resistance is 0.03 ohms. Determine the power generated and the electrical efficiency.
consider a running motor with Z = 6 + j7 ohm A) calculate the line crurrent if the motor is operated at 120 VAC RMS B) calculate the required paralell capacitor value to reduce the line current to a minimum
1. The PowerPC 601 processor addresses a maximum of 2^(32) bytes of memory. What is the maximum number of 64-bit words that can be stored in this memory. 2. A certain IBM 970 processor has a system clock frequency of 1.2 GHz, what is the clock peri..
How are errors handled by the different windowing systems What different types of errors can occur and how do these windowing systems handle these different types of errors.
an induction motor when connected in delta and started direct on line produces a starting torque of 60Nm and consumes 80A. if the same motor is started using the soft start equipment with the voltage set at 0.8 of the line
Draw a circuit model of the path of current through the human body for a person touching a voltage source with both hands who has both feet at the same potential as the negative terminal of the voltage source.
If the fundamental frequency of a square wave is 10 kHz, what are the first three frequency components contained in the square wave
A square wave has a max value of 22 volts, a min value of -46 volts, and a frequency of 44 Hz. Note that it is not centered around the t-axis. what is its rms voltage?
Two loads are connected in parallel. The voltage across the loads is 8kVrms. The first load is rated at 12 kW with a 0.6 lagging power factor. The second load is rated at 20 kVA with a 0.8 lagging power factor. Find the complex power of the two lo..
Design a circuit that can perform BCD addition on two decimal digits. You don't have to design any of the major components you may use (such as adders, comparators, etc.). Assume all those components are available.
Given transfer function of dynamic system: T(s)= (2s^2 + 2s + 3) / (s^3 + 4s^2 + 6s + 10). write down state equation and output equation in Controllable Canonical Form and in Observable Canonical Form.
A balanced positive-sequence wye-connected 60-Hz three-phase source has line-to-line voltages of VL = 208V rms. This source is connected to a balanced wye-connected load. Each phase of the load consists of an impedance of 30 + j40 *
Assume that the Baud rate is 4800, and the clock input to the universal serial communication interface (USCI) module has a frequency of fBRCLK = 32,768 Hz. We want to set up the USCI module in the UART mode
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd