Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Saturated steam at 0.14 bar is condensed in a shell-and- tube heat exchanger with one shell pass and two tube passes consisting of 130 brass tubes, each with a length per pass of 2 m. The tubes have inner and outer diame- ters of 13.4 and 15.9 mm, respectively. Cooling water enters the tubes at 20°C with a mean velocity of 1.25 m/s. The heat transfer coefficient for condensation on the outer surfaces of the tubes is 13,500 W/m2 · K.
(a) Determine the overall heat transfer coefficient, the cooling water outlet temperature, and the steam condensation rate.
(b) With all other conditions remaining the same, but accounting for changes in the overall coefficient, plot the cooling water outlet temperature and the steam condensation rate as a function of the water flow rate for 10 mc 30 kg/s.
the fracture strength of glass may be increased by etching away a thin surface e layer. it is believed that the etching
A 20 MW back-pressure steam turbine receives steam at stagnation pressure of 4 MPa and stagnation temperature of 300oC, exhausting from the last stage at stagnation pressure of 0.35 MPa. The turbine isentropic efficiency is 0.884, and mechanical loss..
Replacing about half of the steel-based materials in a car can reduce the weight of the vehicle by almost 60%. This can lead to nearly a 30% increase in fuel efficiency. What kinds of materials could replace steel in cars (pick at least two)? What wo..
The moment of inertia I2 for strut-2 is twice the moment of inertia I1 for strut-1. If P1 and P2 are the critical buckling loads for strut-1 and strut-2, respectively, how are P1 and P2 related?
initially an insulated rigid tank contains 28.5 kg of water at 23.4oc and 101 kpa. the tank also contains a 3.14 kg
A two-dimensional rectangular plate is subjected to prescribed temperature boundary conditions on three sides and a uniform heat flux into the plate at the top surface. Using the general approach of Section 4.2, derive an expression for the temper..
Determine the eigenvalues and eigenvectors for the following matrices:
a steam power plant has high and low pressures of 20 mpa and 10 kpa respectively and one open fwh operating at 1 mpa
consider the combustion of methane using 20 excess air with a methane conversion of 85. air enters at 300oc and methane
Consider heat transfer through a wall comprised of two solid layers, each 4m x 4m. When perfect contact is maintained between the layers, the steady state temperature profile across the wall might look like that shown below
How do the different components of MITRE's KM system assist in spreading knowledge throughout its labs and in storing knowledge for use in the future - What is the benefit of MITRE's evolutionary approach to KM?
concrete has a density of 2400 kgm3 and a compressive strength of 30 mpa. what is the maximum height of a column of
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd