Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A system is needed to measure flow, which continuously cycles between 20 and 30 gal/min with a period of 30 sec. The required output is a voltage varying from -2.5 to +2.5 V for the cycling flow range. The sensor to be used has a transfer function of ? Q volts, where Q is in gal/min, and an output impedance of 2.0 k?. Tests show that the output of the sensor has 60 Hz noise of 0.8 V rms. Design a signal-conditioning system, including noise filtering, and evaluate your design as follows.
a. Plot output voltage versus flow, and comment on the linearity.
b. Determine the noise on the output as percent FS.
A Si PIN photodiode has an i-Si layer of width 20 µm. The p+ layer on the illumination side is very thin (0.1µm). The PIN is reverse biased by a voltage of 100 V and then illuminated with a very short optical pulse of wavelength 900 nm.
Control Systems and Laplace Transformations, What is the step response of a system whose transfer function has a zero at -1, a pole at -2 and a gain factor of 2?
A silicon NPN bipolar junction transistor is to be used as an amplifier. What are the required bias conditions for this to occur If the emitter voltage is -3V, pick an acceptable base voltage and an acceptable collector voltage for the transistor ..
our senior design team is designing a force sensor to measure a force signal and analyze the signal with a microcomputer (binary system). The analog force signal is between 10 N and 70 N and has the frequency bandwidth of DC - 1000 Hz.
1.A liquid has an enthalpy of vaporization of 30.8 kJ/mol. At 275 K it has a vapor pressure of 117 mmHg. What is the normal boiling point of this liquid 2. In a certain mountain range, water boils at 94°C. What is the atmospheric pressure under the..
What is the shape of the spectrum of the signal? What is the extent of the spectrum in the frequency domain? What is the unit that is applied to the magnitude of the spectrum?
Methods used to eliminate noise from a spatio-temporal signal, Name and describe, in detail, 2 methods used to eliminate noise from a (spatio-temporal) signal. This question requires a clear, detailed explanation of the methods. Mathematical equation..
Rain affects the downlink from the satellite and the overall CNR ratio in the receiver falls by 6.0 dB to 13.0 dB. What is the bit error rate and the time between errors now?
A load has a 20 ohm resistor and a 4 Henry inductor connected in series. It is connected to a power source with v(t) = 100 cos(50t), connected in series to the load. What is the impedance of the load? Use phasor transform methods to obtain your an..
The energy (power) in Watts in an electrical circuit is described by P = VI, where V is volts and I is current
If we want to correct the power factor to 0.9 lagging, what is the value of Q we need to inject.
algorithms to show the differences in the intra prediction in the h.264 and hevc coding standards. it should indicate how the intraprediction in the two coding standards makes a difference in their efficiency.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd