Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
three 50 mm by 100 mm full-sized timbers are fastened by 5-mm diameter bolts spaced at at pitch of 40 mm. If the allowable flexural stress in timber is 8 MPa and the allowable shrea stress is 100 MPa, determine the maximun concentrated load that can be applied at the midpoint of a 3-m simple span. Neglect the weight of the beam.
what will be the final temperature in the tank? how much work will be accomplished over the course of the entire process?
Determine the heat transport rate of energy through an animal skull where average inside surface temperature is 95 degrees farinhiet and whose out outside surface temperature is 90 F. Assume the skull is a spherical shell 7.5 inches in outside dia..
Calculation of percentage heat reduction, Water at 90 C flows through a 50mm bore steel pipe of wall thickness 8 mm. Ambient temperature is 18 C. Calculate the heat loss per metre length of pipe
The rigid gate, is hinged at O and rests against a rigid support at B. What minimum horizontal force, P, is required to hold the gate closed if its width is 3.9 m? Neglect the weight of the gate and friction in the hinge. The back of the gate is e..
Determine the mass flow rate of the air passing through this engine and the rates of heat addition and rejection when this engine produces 1000 hp. Assume constant specific heats at room temperature.
Find the shaft ID needed to obtain a maximum deflection at the center of 3 mm if the shaft OD is 22 cm. Assume the shaft to be the same length between supports as the length of the paper roll.
determine the stresses and the rotation of the body at x= 0.050m and y=0.020m is the displacement field compatible?
If the maximum temperature in the cycle is not to exceed 2200 K, determine the thermal efficiency and the mean effective pressure.
What is a beam? What factors determine the maximum load that it can take without failure?
The compression ratio of an air-standard Otto cycle is 9.5. Prior to the isentropic compression process, the air is at 100 kPa, 17 C, and 600 cm2
Sketch the thermal circuit of the system. Label (using the above symbols) all pertinent nodes and resistances.
The total time it takes to fall is 37 seconds. Find the horizontal lead to hit the target.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd