Determine the mathematical expressions for il and vl

Assignment Help Electrical Engineering
Reference no: EM131206308

a. Determine the mathematical expressions for iL and vL following the closing of the switch in given figure.

b. Determine iL and vL at t = 100 ns.

815_figure.jpg

Reference no: EM131206308

Questions Cloud

Portfolio of three different bonds : Suppose you own a portfolio of three different bonds with the following information:
Coupon bond compared to a zero coupon bond : 1. How many of the coupon bonds must East Coast Yachts issue to raise the $50 million? How many of the zeroes must it issue? 2. In 20 years, what will be the principal repayment due if East Coast Yachts issues the coupon bonds? What if it issues th..
What leadership behavior would expect from christian servant : What leadership behaviors would you expect from a Christian servant leader and how might those behaviors differ from someone who is not a servant leader.
Coupon bonds must east coast yachts : 1. How many of the coupon bonds must East Coast Yachts issue to raise the $50 million? How many of the zeroes must it issue? 2. In 20 years, what will be the principal repayment due if East Coast Yachts issues the coupon bonds? What if it issues th..
Determine the mathematical expressions for il and vl : Determine the mathematical expressions for iL and vL following the closing of the switch in given figure. - Determine iL and vL at t = 100 ns.
Create a vision and mission statement to fit the company : Create a vision and mission statement to fit the company described below: Mohammed Abul and his family own the Long-lasting Boot (LLB) store.
Problem regarding the company shareholders : If a company increased its dividend payout ratio, what effect would this have on its corporate taxes paid? What effect would this have on the taxes paid by the company's shareholders?
Find the mathematical expression for the voltage : Find the mathematical expression for the current through the coil once the switch is closed. - Find the mathematical expression for the voltage across the coil during the same transient period.
Calculate the current ratio and the profit margin for ford : Calculate the current ratio and the profit margin for Ford . You may share your questions as well as your calculations with your classmates in Discussion 1.4.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate v1 in the solution worked out on the site

since v1 is not the voltage across the 7ohm resistor but the voltage across the 9 ohm equivalent resistor shouldn't the current be found by dividing v1 by 9 omhs

  Display the volume level of the audio signal

Design a circuit to drive an 8-LED common-anode bar display, given an 8-bit unsigned binary amplitude value.

  Radio remote control into a steady analogue signal

How can the output from a radio remote control be converted into a steady analogue signal?

  Awheat stome bridge has following ab 20 ohm bc 24ohm cd

a wheat stome bridge has following ab 20 ohm bc 24ohm cd 5 ohm da 50 ohm bd 3 ohm. adca voltage source of 220v

  Construct ladder schematic with holding circuit to energize

Construct a ladder schematic with a holding circuit to energize a relay. The relay when enerigized will turn one of and turn a different lamp on.

  Sketch the circuit schematic with flip-flops

A ripple carry adder is made of full adder cells each having 1 unit of combinational delay. To convert a four-bit ripple carry adder into a four stage pipeline adder proceed as following.

  Explain ideal job and goal of electrical engineer

Briefly explain your ideal job as electrical engineer? Why did you select this career? What goals do you have in this career? How do you plan to get these goals?

  Find the output frequency spectrum-pep and power output

The frequencies Of the signal are 600 Hz and 1.6 kHz with the carrier at 90 kHz. If the rms voltage levels for the 2-tones is 3.22 volts and the load resistor is 71 Ohms, find the output frequency spectrum, PEP, and the average power output.

  What is the maximum bias current allowed for the op amp

Consider the amplifier shown in Figure. With zero dc input voltage from the signal source, it is desired that the dc output voltage be no greater than 100 mV. Ignoring other dc imperfections, what is the maximum offset voltage allowed for the op a..

  Develop an approach using the ite-operator

In other words, your approach should be able to answer the question whether two BDDs are complements of each other, without using the complement operation.

  Find the magnetic field and inductance

A 1000 turns wire are tighly wound on a toroid with a rectangular cross section, the heigh of toroid is 0.5 cm . The inner and outer radii of 2 cm and 3cm respectively. The current in the wire I=100 mA, Ur = 4000. N= 1000, Find H,B,phi and inducta..

  Develop a series 90-30 program that functions a motor

Develop a series 90-30 program that functions a motor forward/reverse controller.. Design your circuit so that the stop push button must be pressed before the motor can switch direction. Also incorporate a 5 second delay to inhibit restart after the ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd