Determine the mass of water supplied to the sprays to

Assignment Help Mechanical Engineering
Reference no: EM13643139

Air at 30 degree C, 80% RH is cooled by spraying water at 12degreeC. This causes saturation, followed by condensation, the mixing being assumed to take place adiabatically and the condensate being drained off at 16.7 degree C. The resulting saturated mixture is then heated to produce the required conditions of 60% RH at 25 degree C. The total pressure is constant at 101 kPa. Determine the mass of water supplied to the sprays to provide 10 m3/h of conditioned air. What is the heater power required?

Reference no: EM13643139

Questions Cloud

A ball is tossed from an upper-story window of a building : a ball is tossed from an upper-story window of a building. the ball is given an initial velocity of 8.20 ms at an angle
Determine the change in internal energy of the system of : how much work is done on the steam when 1.00 mol of water at 100 degrees c boils and becomes 1.00 mol of steam at 100
An electrical motor is used to operate a carnot : an electrical motor is used to operate a carnot refrigerator with an interior temperature of 0 degrees celsius. liquid
When the particle moves with a velocity v2 20 x 104 ms : a particle has a charge of 4.0 x 10-9 c. when it moves with a velocity v1 3.0 x 104 ms at 45 degrees above the y-axis
Determine the mass of water supplied to the sprays to : air at 30 degree c 80 rh is cooled by spraying water at 12degreec. this causes saturation followed by condensation the
A limestone sample was analyzed for its calcium oxide cao : a limestone sample was analyzed for its calcium oxide cao content. a 0.3333 g sample was dissolved in concentrated hcl.
How far must the key be depressed for a keystroke to be : the parallel-plate capacitor used on each key of a computer keypad is a square 0.7 cm on a side. between the plates is
How many liters of the antifreeze ethylene glycol : how many liters of the antifreeze ethylene glycol ch2ohch2oh would you add to a car radiator containing 6.50l of water
Find the temperature to which the air is cooled and the : an air-conditioned room requires 30 m3 min of air at 1.013 bar 20 degree c 52.5 rh. the steady flow conditioner takes

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Compute a values for p u v and d in the english engineering

the reynolds number re is a dimensionless number used in fluid mechanics and is defined as repvdu where p is the fluid

  A steel rod with a diameter of 0625 is loaded in tension

a steel rod with a diameter of 0.625 is loaded in tension with 12000 lb load. in the unloaded condition the rod is 240

  A balloon is to be filled from a helium tank the tank is

a balloon is to be filled from a helium tank. the tank is large and the tank pressure remains effectively constant

  What are some of the potential drawbacks

Simics Central Simics can simulate real workloads at reasonable speeds Is the reported performance a result of optimization or simulator simplicity? What are some of the potential drawbacks of making a completely general simulation environment?

  Calculate how far from the fulcrum the tweezer

Using static equilibrium calculations, calculate how far from the fulcrum the tweezers must be held to avoid damaging the sliver.

  The rod must stretch less than 0125 mm determine an

an engineer determines that a 40 cm long rod of 1020 grade steel will be subjected to a tension of 20 kn. the following

  The kinetic coefficient of friction between the package and

a spring is used to stop a 50-kg package which is moving down a 20 degree incline. the spring has a constant k30 knm

  An ideal gasoline engine has an 81 compression ratio

an ideal gasoline engine has an 81 compression ratio. pressure doubles during the heat addition process. air enters at

  Calculate the mass fraction of helium and the mass density

a he-xe mixture containing .75 mole fraction of helium is used for cooling of electronics in an avionics application.

  The belt connecting these pulleys is represented by two

a pulley 250 mm in diameter drives a second pulley 1000 mm in diameter by means of a belt. the moment of inertia of the

  Water is contained in a closed rigid tank of volume 03 m3

water is contained in a closed rigid tank of volume 0.3 m3 at an initial pressure of 4 bar and a quality of 66. heat

  Calculate the energy for vacancy formation in al given that

calculate the energy for vacancy formation in al given that the equilibrium number of vacancies at room temperature 25

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd