Determine the magnitude of the impedance in ohms

Assignment Help Electrical Engineering
Reference no: EM13291031

1. Determine the magnitude of the impedance in ohms for a 65 mH inductor with excitation at 750 rad/s.

2. Determine the magnitude of the impedance in ohms for a 80 mH inductor in series with a 80 ohm resistor. The frequency of excitation is 600 Hz.

3. Determine the phase angle of the impedance inradians for a 25 mH inductor in series with a 15 ohm resistor. The frequency of excitation is 850 rad/s.

Reference no: EM13291031

Questions Cloud

Determine the crystal frequency if the temperature decreases : A 10 MHz crystal has a negative temperature coefficient of 4.1Hz/MHz/Co. Determine the crystal frequency if the temperature decreases by 41 degrees.
Will samonne be able to transfer her account balance : Under Roseberry's HR policies, Samonne may transfer her pension account balance to some other account provided the balance is 425,000 or less. Will Samonne be able to transfer her account balance?
What reagents obtain a separation via extraction technique : If you were extracting 4-chloroaniline and naphthalene (a mixture in ether), what reagents could you use to obtain a separation via extraction technique
What is the range of his leap : When chasing a hare along a flat stretch of ground, a greyhound leaps into the air at a speed of 14.0 m/s, at an angle of 30.0° above the horizontal.  What is the range of his leap
Determine the magnitude of the impedance in ohms : 1. Determine the magnitude of the impedance inohms for a 65 mH inductor with excitation at 750 rad/s. 2. Determine the magnitude of the impedance inohms for a 80 mH inductor in series with a 80 ohm resistor.
How much charge does that capacitor store : A capacitor with its plates separated by paper stores 5.0 of charge when it is connected to a particular battery. How much charge does that capacitor store
How corporate governance does regulates companies : How corporate governance does regulates companies and what are the rules company abide by and is corporate governance putting restrictions on companies to realize its potential?
Determine the dielectric constant of the oil : An oil-filled capacitor has square parallel plates 26{\rm cm} on a side, separated by 0.47{\rm mm}. Find the dielectric constant of the oil
How does the net present value : How does the net present value (NPV) decision rule relate to the primary goal of financial management, which is creating wealth for shareholders?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the natural reponse of current for rlc circuit

Consider a series RLC circuit disconnected from a source at t=0. The circuit components are R=3 ohms, C = 500 F, and L = 1 H. We assume that Vc(0-) = 20 V and i(0-) = -0A.  a) Find the natural reponse i(t) for t > 0.

  Find the total secondary current and power factor

A 6 pole, 60 hz induction motor is wye connected and has a rated slip of .03 with the follwoing parameters: Rs=0.5 ohms, Rr'=0.3ohms, Xs=J1 ohms, Xr'=J0.35 ohms, Xm=j20 ohmsand the total rotational losses=7300 watts.

  What channel length must be transistor have

In a MOS cascode amplifier, the cascode transistor is required to raise the output resistance by a factor of 40. (1) If the transistor is operated at Vov=0.2V, what must its VA be

  Determine what is the angle of the middle one

Unpolarized light is incident on three polarizers: The first making an angle of 0 degrees with the vertical; the second making an angle of ? degrees with the vertical; and the last one making an angle of 90 degrees with the vertical.

  Calculate the turbine work per unit mass at the throttle

Consider a regenerative Rankine cycle with a 600_C and 4-MPa throttle, a 5-kPa condenser, and an open feedwater heater at 500 kPa. Turbine efficiencies are 85%. Neglect pump work. (a) Draw labeled, coordinated T-s and flow diagrams.

  Is the potential at the point positive-negative or zero

Suppose that the source charges of the two previous problems are present together. The potential at infinity is defined to be 0. a. Is the potential at the point (0.5, 0.5, 0.5) positive, negative, or zero b. Is the potential at (4, 4, 4) positive

  What value get for vswr s from voltage standing wave pattern

i) A table of values of the normalized magnitude of the voltage phasor on the line as a function of position on the line, with the normalization done relative to the value of the voltage magnitude at the voltage maximum point on the line.

  Explain converter operation in a continuous-conduction mode

In a step-down converter, consider all components to be ideal. Let v_0 = V_0 be held constant at 5 V by controlling the switch duty ratio D. Calculate the minimum inductance L required to keep the converter operation

  Determine the output of the generator in watts

A small gasoline engine can put out 18,000 N-m/min of mechanical power. The engine is used to drive an electrical generator that is 80 percent efficient. 1 N-m = 2.78 X 10-4 W-h. Find the output of the generator in Watts.

  Design circuit to take output from each of five microphones

You've formed a band, despite advice to the contrary. Actually, the band is pretty good except for the fact that the lead singer (who owns the drum set, the microphones, and the garage where you practice) is a bit tone-deaf.

  Express the vector as a linear combination of the elements

A canonical base for H7 is {(0000001), (0000010), (0000100), (0001000), (0010000), (0100000), (1000000)}. Express the vector (1010111) as a linear combination of the elements of the canonical base.

  In which characters move around cross obstacles

an inventory control system that keeps track of what items are in stock when the level falls below a certain value ?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd