Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Examining a Power Plant Consider a power plant. At point 1 the working gas has a temperature of T = 25?C. The pressure is 1bar and the mass flow is ?m = 2kg/s. After point 1, the air enters a compressor, at which the pressure is increased to 6 bar. (This is point 2.) After this, the flow is heated to T3 = 700?C. (This is stage 3.) Afterwards, the flow goes through a turbine, at which the pressure is decreased to 1bar again. (This is stage 4.) The flow is then cooled to T1 = 25?C. We're now back in stage 1. We assume that: 1. air behaves like a thermally and calorically perfect gas with Cp = 1004J/kg K, R = 287J/kg K and ? = 1.4. 2. the isentropic efficiency of the compressor is 0.88. 3. the polytropic efficiency of the turbine is 0.85. Answer the following questions
1. Depict the evolution of the cycle in the T - s plane.
2. Determine the net power.
3. Determine the heat received from the hot source.
4. Determine the thermal efficiency of the power plant.
5. Determine the Carnot efficiency associated with the present power plant and compare it with the previous result.
6. Verify the first principle.
Determine the allowable tensile force Tallow in the cable if the allowable compressive stress in the aluminum pole is 90 MPa.
when the efficiency of an otto cycle will approach that of carnot cycle? even with nest possible arrangements the
an axial flow compressor stage has blade rootmean and tip velocities of 150200 and 250 ms. the stage is to be designed
carbon dioxide passing through a heat exchanger at a rate of 100kghr is cooled down from 8000c to 500c. write the
Air initially at 290 K, 1 bar undergoes the following processes: polytropic compression to 5 bar with n = 1.19 and isentropic expansion to 1 bar. Sketch the processes on a T-s diagram, Determine the temperature of state 2 and
Water is the working fluid in a regenerative Rankine cycle. The pressure and temperature at the turbine inlet are 8MPa and 550?C, respectively, and the condenser pressure is 7.5KPa. The mass flow rate of steam entering the turbine is 176kg/s.
five 100 ohm resistors each having 5 tolerance are connected in series. what is the overall nominal resistance and
a closed rigid pressure vessel is filled with a saturated mixture of 1.78 kg of liquid water and 0.22 kg of water vapor
A freight-car axle AB is loaded approximately as shown in the figure, with the forces P representing the car loads (transmitted to the axle through the axle boxes) and the forces R representing the rail loads (transmitted to the axle through the w..
what horsepower must be supplied to a pump that operates at an efficiency of 75 to the flow if water t25degc is pumped
consider a steam turbine operating at steady-state. there is one inlet and one outlet tand adiabatic conditions may be
a spherical communication satellite with a diameter of 2.5m is orbiting around the earth. the outer surface of the
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd