Determine the entropy generated and shows sgen varies

Assignment Help Mechanical Engineering

Reference no: EM13708978

The brake of a vehicle can be modeled as a solid of mass m , with specific heat c and uniform temperature T , initially equal to the ambient temperature T0. During the braking process the brake receives work input W, temperature rises to T and heat transfer occurs in contact with the ambient. The system boundary is a surface of temperature T0.

1. Determine the entropy generated and shows Sgen varies with W, T, To and mc.

2. Show that Sgen is less than W/T0 and explain why.

3. Determine the total entropy generated from the start of the braking process until the brake cools down to T0.Show that this value is greater than that obtained from b.

Reference no: EM13708978

Questions Cloud

Determine the mass flow rate of the steam : Steam enters an adiabatic turbine at 5 MPa, 650°C, and 80 m/s and leaves at 50 kPa, 150°C, and 140 m/s. If the power output of the turbine is 8 MW, determine (a) the mass flow rate of the steam flowing through the turbine and (b) the isentropic effic..

Scrum vs plan-based software development strategies : Develop a visual rendering of each approach using Microsoft Visio or its open source alternative, Dia. Note: The graphically depicted solution is not included in the required page length.

Determine the isentropic efficiency of the compressor : Air is compressed by an adiabatic compressor from 95 kPa and 27°C to 600 kPa and 277°C. Assuming variable specific heats and neglecting the changes in kinetic and potential energies, determine (a) the isentropic efficiency of the compressor and (b) t..

What was the yield stress of your brass after reduction : A brass rod 1.5 cm in diameter is deformed in tension reducing its diameter to 1.128 cm. The data for brass in Fig. 7.19 will be helpful in solving this problem. If the deformation process was performed in one step, what was the yield stress of your ..

Determine the entropy generated and shows sgen varies : The brake of a vehicle can be modeled as a solid of mass m , with specific heat c and uniform temperature T , initially equal to the ambient temperature T0. During the braking process the brake receives work input W, temperature rises to T and heat t..

Determine what the heat flux would be in terms : If you have a plane wall separating hot and cold fluids at temperature T(infinity)1 & T(infinity)2. Using x=0 & x=L as boundary conditions, determine what the heat flux would be in terms of T(infinity)1, T(infinity)2, h1, h2, k, L.

Manufacturing does not require a final shaping operation : manufacturing does not require a final shaping operation. Cooling the outer layer of ceramic quickly may leave it in residual. Ceramics based on SiO2 are known as

Determine the total flow exergy rates at the valve inlet : Water vapor enters a valve with a mass flow rate of 1 kg/s at a temperature of 260 degrees C and a pressure of 3.5 MPa, and undergoes a throttling process to 2.75 MPa (T0=25, P0=100kPa).

Octave is defined as a doubling of the frequency : An octave is defined as a doubling of the frequency. The claim is made that a low-pass Butterworth filter of order n has a roll-off (attenuation) of 6n dB/octave. Calculate the gain in dB for a second-order filter for the cut-off frequency itself, an..

User Account

All Pages