Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The equipment in a power station costs Rs 15,60,000 and has a salvage value of Rs 60,000 at the end of 25 years.
Determine the depreciated value of the equipment at the end of 20 years on the following methods :(i) Straight line method ;(ii) Diminishing value method ;(iii) Sinking fund method at 5% compound interest annually.
A coil with an unknown resistance and inductance isconnected in series with a resistor of 12 ohms and a capacitor of168 micro farads. The circuit is connected across a 220V 50Hzsupply, with lagging power factor of 0.7145.
the upper and lower conducting pltes of a large parallel plate capacitor are separeted by distance d and maintanied
aluminum has the FCC crystal structure. Its atomic weight is 26.98g/mole, and its density is 2.70g/cm3. Determine the atomic radius of a single aluminum atom.
Using a voltage source Vdd=2.5V and an MOSFET with Vt=0.5 V, Kn'=0.8 A/V^2, W=10um and lambda=0, build a common source amplifier which drives a load resistor of 10k ohms. The input signal to the amplifier is a sine wave with a peak value of 0.15 V..
Fix the number of users K (to, say, 30) and the number of receive antennas nr (to, say, 5). Plot the symmetric rate with SDMA, orthogonal multiple access and the intermediate access scheme as a function of SNR (0 dB to 30 dB). How does the interme..
where i need to create a simulink file for buck converter which has a digital controller and feedback where it has
the angular velocity of a polar vector is 720 degreessec. what is the angle 0.001 sec after the vector passes
In a BWR or PWR, steam is generated with a temperature of about 290 °C. If river water used to receive waste heat has a temperature of 20 °C, what is the maximum possible (ideal) conversion efficiency of the reactor's thermal en..
a half wave rectifier circuit with a 1K ohm load operates from a 120V rms 60-Hz household supply through a 10-to-1 step down transformer. It uses a silicon diode that can be modeled to have a 0.7V drop for any current.
The input voltages are inthe range of a few micro volts. Contrast the utility of a BJTversus a MOS transistor for this input stage. How would your choice be different if the application were for a low impedance hall effect sensor used in a wheel r..
This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.
Consider an ideal op-amp in inverting amplifier configuration with feedback impedance Rf=7ohms and an input impedance consisting of a series RL: Ri=9ohms and Li=5H. Let h(t) be the impulse response of the overall amplifer.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd