Determine the density function py y in terms of p and t

Assignment Help Electrical Engineering
Reference no: EM13285315

Two statistically dependent random variables x1 and x2 are applied at the inputs to a threshold detector , the output from which is equal to the number of inputs that exceed the threshold T. Thus, y = 0, 1 or 2. Determine the density function pY (y) in terms of pX1X2(x1, x2) and T.

Reference no: EM13285315

Questions Cloud

Design a current divider that provides a 1-2 current split : Design a current divider that provides a 1:2 current split. Observe the current and power limitations as in the previous item. Another design constraint is that inserting current meters to measure the current division ratio must not upset this rat..
What is the cost of new common stock be : The stock sells for $45, and flotation expenses of 5% of the selling price will be incurred on new shares. What is the cost of new common stock be for Kelly Corp.?
Equity method of accounting for investments : Equity method of accounting for Investments
Determine the force of tension in rope supporting the leg : A setup similar to the one shown in the figure below is often used in hospitals to support and apply a horizontal traction force to an injured leg. Determine the force of tension in the rope supporting the leg
Determine the density function py y in terms of p and t : Two statistically dependent random variables x1 and x2 are applied at the inputs to a threshold detector , the output from which is equal to the number of inputs that exceed the threshold T. Thus, y = 0, 1 or 2.
Explain what is the pressure of air over the mixture : The vapour pressure of a solvent is the amount of gaseous molecules over an open vessel of the solvent. A 50/50 mixture of benzene and toluene has 46.7 Torr of benzene and 13.5 Torr of toluene at STP. What is the pressure of air over this mixture
When the annual income is first recieved at eoy one : annual income from a rental property is expected to start at $1300 per year and decrease at a uniform amount of $50 each year after the first year for the 15-year expected life of the property. the investment cost is $8000 and "i" is 9% per year.
State reacts with the zinc and then neutralizing excess hcl : The zinc content of a 1.45 g ore sample was determined by dissolving the ore in HCl, which reacts with the zinc, and then neutralizing excess HCl with NaOH
What are the rates with continuous compounding : The 6-month, 12-month, 18-month, and 24-month zero rates are 3.00%, 3.50%, 4.00%, and 4.50% with semi-annual compounding.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What sizes of transformers are used for power lines

(1) check a diode out with a regular ohm meter (2) Give an example of where a half wave, full wave or bridge rectifier is used. (3) What sizes of transformers are used for power lines

  Calculate the power in each resistor

If R2 = 2R1, R3 = 3R1 and the total power taken by the circuit is 480 watts. Calculate the power in each resistor

  What is the corresponding incident photon flux

A solar cell is uniformly illuminated by monochromatic light of 700nm with power density of 20 mW/cm^2. What is the corresponding incident photon flux What is the upper limit to Jsc if the bandgap is 1.4eV

  What is the magnitude of the induced emf per phase in rotor

A three-phase induction motor operates at a slip of 3% and has a rotor copper loss of 300W. The rotational loss is 1500W. Determine (a) The air-gap power (b) The power output (c) If the rotor impedance is 0.2+j0.8 ohm/phase,

  Find the hole density np in a doped gaas

A sample of lightly doped GaAs has a room temperature conductivityof 4.04X10-9[S/cm]. If it is known that the electron andhole mobilities areμn=8500[cm2/V·s], andμp=400[cm2/V·s],respectively

  Find the motor speed when the armature current is 2a

A separately excited 300V DC motor has an armature resistance of 1ohm and a field resistance of 100 ohm. The field Voltage is 200V. The no load speed is 1200 rpm and no load armature current 2A

  Find the information content of x and its efficiency

A source X produces symbols A, B, C, D, and E with probabilities 0.5, 0.25, 0.125, 0.0625 and 0.0625 (a) Find the information content of X. (b) Give a fixed length code for X. Compute its efficiency. (c) Derive a Huffman code for X

  Find the system transfer function of a causal lsi system

Find the system transfer function of a causal LSI system whose impulse response is given byh[n] = (-0.5)^n-1 sin[0.5(n-2)]u[n-2] and express the result in positive powers of z. Hint: The transfer function is just the z-transform of impulse respon..

  What is the characteristic equation of the system

The transfer function of a circuit is given by H(s)= 2s+4/4s^2+2s+2 a. Express the transfer function in a form in which the coefficients of the highest power of s are unity in both numerator and denominator.

  What is minimum snr required to achieve 720 kbps data rate

Suppose that OFDM is used with 15 kHz subchannels. (Two subchannels are used as guard channels on either side of the band.) Specify an OFDM symbol rate and modulation format for each subchannel that can achieve the target rate.

  Write the filter frequency response equations of phase

A linear-phase FIR filter should be designed with the ideal magnitude response shown in the following figure. The lower cutoff frequency, fL , is 1,200 Hz, and higher cutoff frequency, fH , is 2,200 Hz. Sampling frequency fS = 8,000 Hz.

  Find how many kilobytes of memory are there on the chip

If memory on a single memory chip ranges from address 100000H to 8FFFFH, how many kilobytes of memory are there on this chip if the memory is byte addressable

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd