Determine the current i flowing through a resistor

Assignment Help Electrical Engineering
Reference no: EM13285106

Determine the current i(t) flowing through a resistor if the cumulative charge has flowed through it up to time (t) is given by

a) q(t)=3.6t mC
b) q(t)=5sin(377t) uC
c) q(t)=0.3[1-e^-0.4t] pC
d) q(t)=0.2t(sin(120pi(t))) nC

Reference no: EM13285106

Questions Cloud

Find the value of the capacitor that needs to be connected : a 10kW 220 V single phase ac motor is operating at .7 lagging power factor. Find the value of the capacitor that needs to be connected in parallel with the motor, if the power factor is to be improved to .95 lagging
Explain water-soluble ionic substances react : In a chemical reaction two water-soluble ionic substances react to form an insoluble solid precipitate in a metathesis reaction. Would you expect DS to be positive, negative, or close to zero for this reaction
Determine how tall is the antenna : makes an angle of 35.2o with the horizontal. In part b the person is looking at the top of the antenna, determine How tall is the antenna
A submarine submerges by admitting seawater : A submarine submerges by admitting seawater (density = 1030kg/m^3) into its balast tanks.  Consider a ballast tank with its outlet at the bottom.  If the tank is filled to a depth of 0.61 meters and the air pressure in the tank is 2.76 atm, what is t..
Determine the current i flowing through a resistor : Determine the current i(t) flowing through a resistor if the cumulative charge has flowed through it up to time (t) is given by a) q(t)=3.6t mC b) q(t)=5sin(377t) uC c) q(t)=0.3[1-e^-0.4t] pC d) q(t)=0.2t(sin(120pi(t))) nC
What is the peaks elevation : When driving west toward the Rocky Mountains, you see a peak 3.7 above the horizon. What is the peak's elevation
Based on review of global health disparities across inter : Based on the review of global health disparities across inter/intra national countries, analyze data by the use of epidemiological analytical methods to infer the factors or causes for these public health disparities.
Explain freezing point and kf constant for cyclohexane : Quinine is a natural product extracted from the bark of the cinchona tree, which is native to South America. Quinine is used as an antimalarial agent. When 1.41 g of quinine is dissolved in 25.0 g of cyclohexane, the freezing point of the solution..
Find the current-i through the light bulbs : Three light bulbs are connected in series to a 100-V battery in a circuit. Each light bulb dissipates 30W, 40W, and 50W, Respectively. Find the current (I) through the light bulbs.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Sketch the output signal waveform

Assume that in addition to the sine-wave signal you have a dc reference voltage of 1.5 V available. Sketch the output signal waveform.

  How many total terms and literals are present in equations

Consider two Functions F = E(1,2,3,5,7,9) and G = E(0,5,7,8,9,11,13,15) a) Use K-maps to minimize the function Fb) Use K-maps to minimize the function G c) How many total terms and literals are present in the two equations

  Determine the wave number and the angular frequency

the wavelenght of green light Lamda =550nm. Determine the wave number, the angular frequency,and the peroid of the wave. The speed of light is 3*10^8 m\s.

  Generate a clock signal with 5 khz frequency

Write an asm HCS12 program to flash LEDs on a dragon+ board three times when SW5 is pressed with a 5 kHz frequency, and 50% duty cycle clock signal. Generate a clock signal with 5 kHz frequency, and 50% duty cycle.

  Design the details of the d-a using a weighted resistor

design the details of the D/A using a Weighted Resistor( NOT R-2R) technique, as well as the logic details of the sequencer/decision maker/state machine which sequences the A/D through its conversion steps to convert an analog input into a 4-bit b..

  Design a circuit that implements the function with vhdl code

Use a K-Map to design a circuit that will accept 5-bit input, and output the value left-shifted by 1. For example, if the input is 10101, the output is 01010. Design a circuit that implements this function. Write the VHDL code.

  Design 3 stage amplifier with the input signal

Design 3 stage amplifier with the following requirement input signal = 5 mV with R=10k ohms over all gain > 1000 power supply: Vcc = 5V, Vee = -5V Rin > 1 Mega Ohms Rout = 100 ohms 1st Stage BJT must use inverting

  Explain voltage in complex forms

Voltage in complex forms, An engine consumes 10kw of power and 4kvar reactive power at a current of (6+j4)Amps

  Determine which is closest to the numeric value 50

Develop the pseudo-code below for a program that will retrieve 2 bytes (NUM1 and NUM2) from memory, determine which is closest to the numeric value 50, and indicate the result by setting a variable named "CLOSEST" to 1

  Determine the value of the resistance in terms of parameters

Show that a linear dependent current source controlled by a voltage appearing across an element in parallel with the dependent source is equivalent to a resistor. Determine the value of the resistance in terms of the parameters of the dependent so..

  Consider a communications channel with a passband

Consider a communications channel with a passband of 3 kHz to 27.4 kHz. A modem will be connected to this communications channel and the modem will operate with a signaling rate that is 0.56 the maximum allowable signaling rate for this communicat..

  Determine the number of resistors and current in each branch

A certain parallel resistor circuit consists of only ½ W resistors. The total resistance is 1.0 k-ohm, and the total current is 50 mA. If each resistor is operating at one-half its maximum power level

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd