Determine the complex reflection coefficient at the load

Assignment Help Electrical Engineering

Reference no: EM13272704

A 50-O lossless line is terminated in a load impedance of 50 + j 100 O. If the wavelength is 20 cm, determine:

(a) the complex reflection coefficient at the load,
(b) the standing-wave ratio,
(c) the locations of the voltage maximum and voltage minimum nearest to the load, and
(d) the input impedances at the locations you found in part (c) looking towards the load.

Reference no: EM13272704

Questions Cloud

Find the load impedance of lossless coaxial cable : Using a 100-Ω slotted lossless coaxial cable, it is found that the distances from the load to the first and second voltage maxima are 1 and 11 cm, respectively, and the standing wave ratio S = 2. Find the load impedance.

Explain the melting points of nafand nacl : The melting points of NaF, NaCl, NaBr and NaI are 988, 801, 755 and 651 degrees Celsius, respectively. Are these data consistent with ideas developed in Section 12-5

Determine the transmission line parameters of coaxial cable : Determine the transmission line parameters of a coaxial cable that uses aluminum inner and outer conductors with radii a = 2.5 mm and b = 5 mm, respectively, and polystyrene (which is nonmagnetic) as an insulator.

What was the current in the primary : A certain transformer has 500 turns on the primary. If 10 volts are applied to the primary, what was the current in the primary

Determine the complex reflection coefficient at the load : A 50-O lossless line is terminated in a load impedance of 50 + j 100 O. If the wavelength is 20 cm, determine (a) the complex reflection coefficient at the load, (b) the standing-wave ratio,

What mass of water vapor diffuses through tube each hour : a lower tank contains water while an upper tank contains air with a negligable concentration of water vapor. what mass of water vapor diffuses through the tube each hour

How to implement a magnitude comparator circuit : Implement a magnitude comparator circuit which compares two-bit binary numbers A and B, and provides 3 outputs (A>B, A=B, A

How much potential difference is induced between wing tips : A 747 with a wingspan of 60 m is flying across an area of the earth where the earth's magnetic field is 5 x 10 -4 T. how much potential difference is induced between the wing tips

Find the input offset voltage of an op amp : An op amp wired in the inverting configuration with the input grounded, having R2=100k-ohm and R1=1k-ohm, has an ouput dc voltage of -0.4 V. If the input bias current is known to be very small, find the input offset voltage.

User Account

All Pages